1.12 Deep Discharge Cut-Off Circuit
PUSH
21
3
The Deep Discharge
If this occurs, switch the loudspeaker system Off (to Position 0) and immediately recharge the battery.
1.13 Connecting Signal Sources
All inputs have at least 10 dB of headroom.
1.13.1 Input 1 and Input 2 pin connectors
Input 1 and Input 2 are combo jacks that accept balanced or unbalanced signals from either XLR male connectors or ¼ in. phone plugs.
Input 1 and Input 2:
Pin 1 | Ground |
Pin 2 | + signal |
Pin 3 |
Balanced input signals - cable configurations:
Cables for balanced signals that will be connected to Input 1 or Input 2 should be configured as follows:
XLR male connector:
1 | Pin 1 | Ground (shield) |
2 | + signal | |
| Pin 2 | |
| Pin 3 | |
| 3 |
|
¼ in. TRS (stereo) phone plug:
|
|
|
|
|
|
|
|
|
|
|
| Tip | + signal |
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
| S |
|
| eve |
| Ring | |||
| Tip |
| le |
| Sleeve | Ground (shield) | |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Ring
Unbalanced input signals - cable configurations:
For unbalanced input signals, the simplest solution is to use a ¼ in. mono (TS) phone plug. Connect the "+ signal" to the Tip and the Ground (shield) to the Sleeve.
Warning! | Connect unbalanced microphones or any other equipment that has an unbalanced | ||||||
| connector (e.g. ¼ in. mono phone plug) to INPUT 2 (unless INPUT 1 will ONLY be used in the | ||||||
| LINE position). INPUT 1 has phantom power in the MIC or AUX positions and this may cause | ||||||
| permanent damage to an unbalanced microphone when an unbalanced connector is used. | ||||||
|
|
|
|
| |||
|
| Connectors for unbalanced signals should be configured as follows (refer to previous | |||||
|
| Warning): |
|
|
|
|
|
|
|
|
|
| |||
|
| XLR male connector | ¼ in. TRS (stereo) phone plug | ¼ in. TS (mono) phone plug | |||
|
|
|
|
|
|
|
|
|
| Pin 1 | Ground | Tip | + signal | Tip | + signal |
|
|
| (shield) |
|
|
|
|
|
|
|
|
|
|
|
|
|
| Pin 2 | + signal | Ring | shorted to Sleeve |
|
|
|
|
|
|
|
|
|
|
|
| Pin 3 | shorted to | Sleeve | Ground (shield) | Sleeve | Ground (shield) |
|
|
| Pin 1 |
|
|
|
|
|
|
|
|
|
|
|
|
