![](/images/new-backgrounds/1319987/31998711x1.webp)
ASSEMBLY
To hire an authorized service technician to assemble the treadmill, call
Assembly requires the included hex key and your own Phillips screwdriver
with a shaft at
least 6 in. (15 cm) long and wire cutters .
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of the manual. The number after the parentheses shows the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it is preat- tached to one of the parts to be assembled. Extra hardware may be included. To avoid damaging plastic parts, do not use power tools for assembly.
Ground Screw | Screw |
|
| 2.25" Extension Leg Bolt | |
|
| |
| Star Washer |
|
Front Endcap |
|
|
Screw |
| 2.5" Extension Leg Bolt |
|
| |
1" Tek Screw | Extension Leg Nut | Handrail Bolt |
1. Make sure that the power cord is unplugged. | 1 |
| |
With the help of a second person, carefully tip |
| ||
|
| ||
the treadmill onto its left side as shown. Partially | 84 | 14 | |
fold the Frame (58) so the treadmill is more sta- | |||
|
| ||
ble. Do not fully fold the Frame until the |
| 44 | |
treadmill is completely assembled. |
| ||
Insert an Extension Leg (89) into the base of the | 92 |
| |
Uprights (84). Hold an Extension Leg Nut (67) in | 8 |
| |
the bottom of the Extension Leg, and thread a |
| ||
2.25" Extension Leg Bolt (92) with a Star |
| 8 | |
Washer (8) into the top of the Extension Leg. |
| ||
|
| ||
Next, thread a 2.5" Extension Leg Bolt (65) with a |
|
| |
Star Washer (8) into the bottom of the Extension | 89 | 67 | |
Leg. Firmly tighten the Extension Leg Bolts. | |||
| 65 | ||
|
| ||
Slide a Front Endcap (44) onto the base of the | 58 |
| |
Upright (84). Finger tighten a Front Endcap |
|
| |
Screw (14) into the Front Endcap and the base. |
|
| |
Do not fully tighten the Screw yet. |
|
| |
| 6 |
|