5. While a second person holds the console as- |
|
|
|
| 5 |
| |
sembly near the Handrail (20), attach the |
|
| |
|
|
| |
ground wire to the indicated hole in the Handrail |
|
|
|
|
|
| |
with a Ground Screw (33). |
|
|
|
|
| Ground |
|
|
| Wire |
|
|
| 33 |
|
|
| Hole |
|
|
| 20 |
|
|
|
| Console |
|
|
| Assembly |
6. While the second person continues to hold the | 6 |
|
|
console assembly, locate the wire underneath |
|
| |
|
|
| |
the console assembly. |
|
|
|
Connect the wire from the console assembly to |
|
|
|
the Wire Harness (77). See the inset drawing. |
|
|
|
The connectors should slide together easily |
| Wire | 77 |
and snap into place. If they do not, turn one |
|
|
|
connector and then try again. IF THE CONNEC- |
|
|
|
TORS ARE NOT CONNECTED PROPERLY, |
|
|
|
THE CONSOLE MAY BE DAMAGED WHEN | Console | 77 |
|
THE POWER IS TURNED ON. Insert the con- |
| ||
nectors downward into the Handrail (20). | Assembly |
|
|
|
|
| |
| 20 |
| |
7. Set the console assembly on the Handrail (20). | 7 |
|
|
Be careful to avoid pinching any of the | Console Assembly |
| |
|
| ||
wires. Make sure that the ground wire (see | Channel |
|
|
step 5) and the wire from the console assem- |
|
| |
|
|
| |
bly (see step 6) are in the indicated channel. |
|
|
|
Hand tighten five Screws (3) into the Handrail |
|
|
|
(20) and the console assembly. Do not put |
|
|
|
Screws into the two indicated holes. Start all |
|
|
|
five Screws, but do not tighten them yet. |
|
|
|
|
| 20 |
|
| 3 | 3 | 3 |
|
| ||
|
| No Screws |
|
| 8 |
|
|
