Healthrider HRCCEL59930 manual Assembly, Wrenches Rubber mallet Pliers

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the

included allen wrenches, assembly requires a phillips screwdriver			, two adjustable
wrenches	, a rubber mallet	, and pliers	.

As you assemble the elliptical exerciser, use the drawings below to identify the small parts used for assembly. The number in parenthesis below each drawing is the key number of the part, from the PART LIST on pages 24 and 25. The number following the key number is the quantity used for assembly. Note: Some small parts may have been pre-assembled. If a part is not in the parts bag, check to see if it has been pre-assembled.

M6 Washer	M8 Washer	Torque Washer	M10 Split	M8 Nylon Jam		M10 Nylon
(64)–2	(66)–2	(113)–2	Washer (57)–3	Nut (86)–6		Locknut (89)–4
M6 x 16mm Patch		M6 x 48mm Flat	M8 x 19mm Patch		M10 x 25mm Button
Screw (76)–4		Head Screw (83)–4	Screw (111)–2			Screw (114)–3
M8 x 63mm Bolt Set (65)–2			M4 x 16mm Round			M4 x 16mm
			Head Screw (96)–1			Screw (98)–4
	M10 x 92mm Carriage Bolt (63)–2
					M8 x 42mm Button
					Bolt (85)–4
	M10 x 105mm Carriage Bolt (115)–2				M8 x 35mm Button
						Bolt (105)–2

1.Identify the Front Stabilizer (8), which has Wheels (109) attached to the front. While another person lifts the front of the Frame (1), attach the Front Stabilizer to the Frame with two M10 x 92mm Carriage Bolts (63) and two M10 Nylon Locknuts (89).

While another person lifts the rear of the Frame (1), attach the Rear Stabilizer (not shown) to the Frame with two M10 x 105mm Carriage Bolts (not shown) and two M10 Nylon Locknuts (not shown).

1
	109
63
8	89
	1

5