Trouble-shooting and Maintenance
Inspect and tighten all parts each time you use the home gym system. Replace any worn parts immediately. The home gym system can be cleaned using a damp cloth and mild
Tightening the Cables
Woven cable, the type of cable used on the home gym system, can stretch slightly when it is first used. If there is slack in the Cables before resistance is felt, the Cables should be tightened.
Slack can be removed by moving one or both of the 3 1/2Ó Pulleys (24) attached to the Adjustable Pulley Frame (23).
To move one Pulley, unscrew the 3/8Ó Nylon Locknut (50) and the 3/8Ó x 2Ó Bolt (54). Remove the Cable Trap (25) and Pulley (24) from the Adjustable Pulley Frame (23).
Note: Begin by moving one Pulley to the second adjustment hole. If the Cables are still too loose, move the same Pulley to the third hole. If additional adjustment is needed, move the second Pulley until the Cables are tight.
The Cables can also be tightened by adjusting the bolt at the end of the Low Cable (72). To do this, the Shrouds (35, 36, not shown) must be removed. Follow assembly steps 45 to 47 in the opposite order to remove the Shrouds.
When the Shrouds have been removed, insert the Weight Pin (19, not shown) between the third and the fourth Weight (21), counting from the top. See ÒChanging the Weight SettingÓ on page 20 for instructions on moving the Weight Pin.
Loosen the 1/2Ó Plain Nut (68) securing the bolt at the end of the Low Cable (72). Tighten the bolt a couple of turns into the Weight Tube (17) until the Cables feel tighter. Tighten the Plain Nut to prevent the bolt from turn- ing.
Note: If a Cable tends to slip off the Pulleys often, the Cable may have become twisted. Remove the Cable and
If the Cables need to be replaced, see ORDERING REPLACEMENT PARTS on the back cover of this manual.
1 |
|
23 |
|
| Adjustment Holes |
50 |
|
| 54 |
24 | 25 |
| |
36 |
|
| 72 |
| Bolt |
| 68 |
| 17 |
| 21 |
23
