ASSEMBLY
Before beginning assembly, carefully read the following information and instructions:
¥Place all parts of the home gym system in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed.
¥For help identifying the small parts used in assembly, use the PART IDENTIFICATION
CHART located in the center of this manual.
Note: Some small parts may have been pre- attached for shipping. If a part is not in the parts bag, check to see if it has been
¥As you assemble the home gym system, be sure that all parts are oriented as shown in the drawings.
¥Tighten all parts as you assemble them, unless instructed to do otherwise.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE REQUIRED FOR ASSEMBLY:
¥Two (2) adjustable wrenches 
¥One (1) phillips screwdriver 
¥One (1) rubber mallet 
¥Lubricant, such as grease or petroleum jelly, and soapy water will also be needed.
Assembly will be more convenient if you have the following tools: A socket set, a set of
1.Before beginning assembly, be sure that you have read and understand the information in the box above.
Insert four 3/8Ó x 2 1/2Ó Carriage Bolts (60) up through the Base (1). Note: It may be helpful to tape the Carriage Bolt heads in place under the Base. If you do tape the Carriage Bolt heads, remove the tape once you finish assembly.
1
1
60
60
5
