18.Insert a 1/4Ó x 2 1/2Ó Carriage Bolt (57) through the center hole in a Seat Plate (29). Attach the Seat Plate to the Seat (23) with two 1/4Ó x 3/4Ó Bolts (56).
Attach another Seat Plate (29) to the Seat (23) in the same manner.
Insert the 1/4Ó x 2 1/2Ó Carriage Bolts (57) through the holes in the Seat Frame (13). Tighten a 1/4Ó Nylon Locknut (54) with a 1/4Ó Washer (55) onto each Carriage Bolt.
19.Press a 1 3/4Ó Square Inner Cap (65) into each end of the Leg Lever (12). Press a 1 3/4Ó Square Inner Cap into the Seat Frame (13)
Lubricate the 3/8Ó x 2 1/2Ó Bolt (51). Attach the Leg Lever (12) to the Seat Frame (13) with the Bolt and a 3/8Ó Nylon Jam Nut (74). Do not overtight- en the Nylon Jam Nut. The Leg Lever must be able to pivot freely.
Insert the 3/8Ó x 2 1/2Ó Eyebolt (53) into the Leg Lever (12) from the direction shown. Tighten a 3/8Ó Nylon Locknut (39) with a 3/8Ó Flat Washer (46) onto the Eyebolt.
20.Turn the Lock Knob (28) counterclockwise until it turns freely. Pull the Lock Knob and hold it. Rest the Seat Frame (13) on one of the pins in the Frame (2). Release the Lock Knob. Turn the Lock Knob clockwise until it is firmly tightened.
Press 3/4Ó Round Inner Caps (26) into the ends of each Pad Tube (25).
Insert a Pad Tube (25) into the Seat Frame (13). Slide a Foam Pad (27) onto each end of the Pad Tube.
Insert the other Pad Tube (25) into the Leg Lever (12). Slide a Foam Pad (27) onto each end of the Pad Tube.
18 |
| |
23 |
| |
57 | 57 | |
29 | ||
| ||
29 |
| |
56 | 56 | |
| ||
| 13 | |
| 55 | |
| 54 | |
19 |
| |
65 |
| |
74 | 13 | |
51ÑLubricate | ||
12 | ||
53 | ||
| ||
39 |
| |
46 |
| |
| 65 | |
20 | 2 | |
| ||
| 13 | |
| 28 | |
27 |
| |
| 26 | |
| 25 | |
12 | 26 | |
27 |
21.Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENT, beginning on page 12 of this manual.
Before using the home gym system, pull the cable a few times to be sure that it moves smoothly over the pulleys. If the cable does not move smoothly, find and correct the problem. IMPORTANT: If the cable is not properly installed, it may be damaged when a high resistance setting is used. See the CABLE DIA- GRAM on page 15 of this manual for proper cable routing. If there is any slack in the cable, you will need to remove the slack by tightening the cable. See
11
