TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, see the front cover of this manual.

PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor is plugged into a properly grounded outlet (see page 9). Use only a single-outlet surge suppressor that meets all of the specifications described on page 9. Important: The treadmill is not compatible with GFCI-equipped outlets.

b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.

c. Check the circuit breaker located on the treadmill

c

 

near the power cord. If the switch protrudes as

 

 

 

shown, the circuit breaker has tripped. To reset the

Tripped

Reset

circuit breaker, wait for five minutes and then press

 

 

the switch back in.

 

 

PROBLEM: The power turns off during use

SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the

circuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c. Remove the key from the console. Reinsert the key fully into the console.

d. If the treadmill still will not run, see the front cover of this manual.

PROBLEM: The speed display on the console does not function properly

SOLUTION: a. Remove the key and UNPLUG THE POWER CORD.

a

 

Remove the hood from the treadmill. Locate the Reed

 

1/8”

 

Switch (21) and the Magnet (43) on the left side of the

42

Pulley (42). Turn the Pulley until the Magnet is aligned

76

with the Reed Switch. Make sure that the gap be-

21

43

tween the Magnet and the Reed Switch is about

 

 

1/8”. If necessary, loosen the 3/4” Screw (76), move

Top

 

the Reed Switch slightly, and then retighten the

 

Screw. Reattach the hood, and run the treadmill for a

View

 

few minutes to check for a correct speed reading.

 

 

22

Page 22
Image 22
Healthrider HRTL39305.0 manual Troubleshooting, Problem The power turns off during use, Top