2.Identify the Latch Assembly (76). Make sure that the sleeve has been slid over hole 1 and that the knob is locked into hole 1. Pull on the sleeve to make sure it is locked into place.

Next, make sure that the knob (46) is locked into hole 2. If it is not, pull out the tube until you see hole 2 and then slide the tube back in until the knob locks into hole 2.

2

Hole 2

 

Knob

Tube

Hole 1

 

Sleeve

76

3. Remove the plastic ties from the ends of the

 

 

 

3

 

 

Latch Assembly (76).

 

 

 

 

 

 

 

55

 

 

 

 

 

Hold the Latch Assembly (76) with the large bar-

 

 

 

rel and the knob positioned as shown; make

20

 

 

sure that all of the holes are aligned (see the

4

 

inset drawings). Next, attach the lower end of

 

Top

 

 

the Latch Assembly to the bracket on the Upright

 

 

 

(85) with the Lower Latch Bolt (3) and a Nut (20).

 

76

Holes

 

 

Then, attach the upper end of the Latch

Knob

 

 

 

 

 

Assembly (76) to the bracket on the Frame (55)

 

 

 

with the Upper Latch Bolt (4) and a Nut (20).

 

Large

 

Note: It may be necessary to move the Frame

 

Barrel

 

back and forth to align the Latch Assembly with

 

 

 

the Bracket.

 

85

 

 

 

 

Lower the treadmill frame (see HOW TO LOWER

 

 

Holes

 

 

 

THE TREADMILL FOR USE on page 25).

20

 

 

 

 

Bottom

 

 

3

 

 

 

4. Remove the band securing the Upright Wire

4

 

 

Harness (73) to the right Upright (85). Have a

 

 

 

 

 

second person hold the console assembly near

 

 

 

the right Upright.

Console

 

 

 

Assembly

 

 

Connect the Upright Wire Harness (73) to the wire

 

 

 

harness extending from the console assembly.

 

 

 

See the inset drawing. The connectors

 

 

 

should slide together easily and snap into

73

 

 

place. If they do not, turn one connector and try

 

 

 

 

 

again. IF THE CONNECTORS ARE NOT CON-

 

 

 

NECTED PROPERLY, THE CONSOLE MAY

 

 

 

BE DAMAGED WHEN THE POWER IS

85

 

73

TURNED ON. Then, insert the connectors into

 

 

 

the right Upright (85).

 

 

 

 

8

 

 

Page 8
Image 8
Healthrider HRTL89406.2 manual Sure that all of the holes are aligned see, Again. if the Connectors are not CON