5.Remove the band securing the TV Cable (63) to the left Upright (85). Connect the TV Cable to the cable extending from the console assembly. Then, insert the TV Cable into the left Upright.
Next, insert the brackets on the Handrails (70) into the left Upright (85) and the right Upright (not shown). Make sure that no wires are pinched.
6.Attach the console assembly to the Uprights (85) with four Console Bolts (72) and four 3/8” Star Washers (71) (only one side is shown). Start all four Console Bolts before tightening any of them.
7.Note the location of the 75 ohm terminal near the power cord. For the television to operate properly, a 75 ohm CATV cable must be connected to the 75 ohm terminal (see page 10).
5 | Console |
|
|
| |
| Assembly |
|
|
| Bracket |
|
| 70 |
| 63 |
|
|
| 85 |
6 |
|
|
85 |
|
|
| 72 | Console |
|
| |
71 |
| Assembly |
|
| |
7 |
|
|
|
| 75 Ohm |
|
| Terminal |
8.Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see page 27). To protect the floor or carpet from damage, place a mat under the treadmill.
9
