Hearth and Home Technologies GFK-210-C installation manual INSTALLING THE BLOWER Metal Inserts

4.0 INSTALLING THE BLOWER (Metal Inserts)

1.Remove factory-installed blower brackets by removing four screws. Brackets are only used for the FireBrick inserts. See Figure 3.

2.Remove appliance from wall.

3.Remove access panel by removing four screws. See Figure 4.

4.Screw blowers to access panel on rear of insert with four screws. See Figure 5.

5.Plug the blower cord into the blower receptacle. Con- nect the white, black, and green spade connectors from blower cord harness to each blower. See Figure 1 and Figure 7.

6.Bundle and zip tie any wires to keep them from contact- ing the fan blades. See Figure 7, Detail A.

7.Reinstall access panel.

NOTE: Install the blower using the access panel located on the back side of the appliance.

Figure 3. Remove Blower Brackets

Figure 4. Remove Access Cover

Figure 5. Attach Blowers to Access Cover

2 Hearth & Home Technologies • GFK-210-C Blower System Instructions 2201-938 Rev. E • 9/12