NOVUS
G.FINISHING
1.COMBUSTIBLE FINISHING MATERIAL
Material made of or surfaced with wood, compressed paper, plant fibers, plastics, or any material capable of igniting and burning, whether flame proofed or not, plastered or unplastered (this includes drywall).
2.NONCOMBUSTIBLE FINISHING MATERIAL
Material which will not ignite and burn. Such materials are those consisting entirely of steel, iron, brick, tile, concrete, slate, glass or plasters, or combination thereof, or have a UL Fire rating of Zero (0).
3.HIGH TEMPERATURE SEALANT MATERIAL
Sealants that will withstand high temperatures: General Electric RTV103 (Black) or equivalent. Rutland, Inc. Appliance Mortar #63, or equivalent.
A high temperature sealant, 1/8” inch wide minimum, must be used to close off gaps between the appliance and facing to prevent cold air leaks. See Figure 17.
Note: If an optional fan or hand held remote control are to be used, wiring must be done prior to finishing to avoid reconstruction.
Figure 17 - Finishing Materials
WARNING!
Grilles on this appliance cannot, in any way, be cov- ered as it may create a fire hazard.
Note: The remote wall switch must be wired prior to applying the finishing material in order to avoid reconstruction.
H. APPLIANCE PREPARATION
1. ATTACHING THE HOOD | 4. GLASS AND SCREEN REMOVAL |
The hood is to be located above the glass panel. The hood must be attached or a fire hazard may result. Locate the four screws just inside the upper section of the appliance. Position the hood and slide into position. Tighten the four screws. See Figure 18.
2.UPPER GRILLE PANEL REMOVAL
Grasp the upper grille panel and remove the rubber pins holding the grille. See Figure 19.
3.CONTROL ACCESS PANEL REMOVAL
Release the spring pin on the right hand side of the control access panel. See Figure 20.
See page 21 of this manual.
Figure 19 - Upper Grille Panel Removal
|
|
|
|
|
|
|
|
|
|
| Figure 18 - Hood Placement |
| Figure 20 - Control Access Panel Removal | |
|
|
|
|
|
|
|
|
|
|
34615 Rev G | 14 |
| ||
