Hearth and Home Technologies GNBC36 Junction Box Installation Instructions, d.Junction Box Wiring

NOVUS B-VENT INSTALLATION INSTRUCTIONS

c.Intermittent Pilot Ignition

This appliance is equipped with an intermittent pilot control valve which operates on a 3 volt system. See wiring diagram, Figure 15.

The appliance is supplied with a battery pack and a 3 volt AC transformer, which requires the installation of the supplied junction box. It is highly recommended that the junction box be installed at this time to avoid reconstruction. The battery pack requires two D cell batteries (not included). Batteries cannot be placed in the battery pack while using the 3 volt AC transformer. Conversely, the transformer must be unplugged if the battery pack is used.

Note: This appliance must be electrically wired and grounded in accordance with local codes or, in the absence of local codes, with National Electric Code ANSI/NFPA 70-latest edition or the Canadian Electric Code, CSA C221.1.

CAUTION:

Battery polarity must be correct or control module damage will occur.

Figure 15 - Intermittent Pilot Ignition Diagram

d.Junction Box Wiring

We recommend you operate the two outlets on separate circuits, one side hot full time, one side switched. This allows independent operation of the appliance and fan. Independent operation is obtained by using minimum 14-3 with ground Romex and separating the two outlets by breking out the tab as shown in Figure 16.

6.JUNCTION BOX INSTALLATION INSTRUCTIONS

a.Remove the junction box assembly from the valve compartment.

b.If the box is being wired from the OUTSIDE of the appliance:

1)Loosen two screws on the Romex connector, feed the necessary length of wire through the connector and tighten the screws.

2)Make all necessary wire connections to the receptacle and assemble the receptacle and cover to the junction box.

Figure 16 - Junction Box Detail

3)Attach the junction box assembly to the outside of the appliance with the two screws provided.

c.If the box is being wired from the INSIDE of the appliance:

1)Pull the electrical wires from outside the appliance through this opening into the valve compartment.

2)Loosen the two screws on the Romex connector, feed the necessary length of wire through the connector and tighten the screws.

3)Make all necessary wire connections to the receptacle and assemble the receptacle and cover to the junction box.

4)Attach the junction box assembly to the inside of the appliance with the two screws provided.

d.If the box is not to be wired at the time of appliance installation, assemble the receptacle and cover to the box and install on the inside of the appliance.

12-02 13 34615 Rev G