R
Yosemite Wood Stove
MAINTENANCE
BRICK REPLACEMENT INSTRUCTIONS
Brick Set Part Number: BRICK-7004
6
The firebox of your stove is lined with high quality firebrick which has exceptional insulating properties. There is no need for a grate, simply build a fire on the firebrick.
1.Be certain coals are completely cold. Remove all old brick and ash from unit and vacuum out firebox.
2.Remove new brick set from box and lay out to diagram as shown.
3.Lay bottom bricks in unit.
4.Install rear bricks on the top of the bottom bricks. Slide top of bricks under clip on back of firebox wall and push bottom of brick back.
5.Install side bricks. Slide top of brick under clips on side of firebox and push the bottom of the brick until it is flush with the side of the unit.
4 | 4 | 6 | 4 | 4 |
4 |
| |||
|
|
| ||
4 |
|
|
|
|
| 1 | 2 |
|
|
3 |
| 1 |
| |
|
|
| ||
3 |
|
| 5 | |
|
| 3 | ||
|
|
|
|
Use Part
Nbr | Brick Size | Qty |
1 | 2 | |
| (see drawing) |
|
2 | 9" x | 1 |
3 | 4 | |
4 | 6 | |
5 | 1 | |
6 | 1 | |
| hole 1 (see drawing) |
|
3 |
1 | |
|
70.0o
BAFFLE REMOVAL & INSTALLATION
NOTE: The baffle is 2700° Fiber Board. Removing hardware exposed to combustion processes can be frustrating. If your reason for removing the baffle is simply to clean the chimney, you have alternatives which will save time and effort. Call a qualified chimney sweep or an authorized
Baffle Board
1.Remove all ash from firebox, and extinguish all hot embers before disposal into a metal container.
2. | Remove ceramic blanket and baffle together. | Push baffle board up slightly to | |
3. | With a 3/16” Allen wrench, remove the front manifold tube | ||
allow room to turn the handle |
retainer bolts on the air channel under the end of the
front tube. See Figure 25A. NOTE: Soak the bolts with penetrating oil for at least 15 minutes before trying to remove it.
Figure 25A
4.To remove manifold tube, slide the tube to one side until one end is out of its hole. Then, while lifting that end of the
fiber board baffle, pull tube up over the air channel and out | Ceramic Blanket |
of hole at the other end. | |
5. Slide fiber board baffle forward to front of stove and straight | Baffle Board |
out through door. See Figure 25B. |
|
6.To install the fiber board baffle, repeat steps 2 through 4 in reverse. Be sure the fiber board baffle and ceramic blanket are fully pushed back into position and the blanket is down flat. The front of the blanket should be flush with
the front of the baffle. | Figure 25B |
|
|
|
|
Page 25 |