R
Yosemite Wood Stove
|
|
1 | Place the unit in a location near the final installation |
| area and follow the procedures below: |
2 | Open the stove and remove all the parts and articles |
| packed inside. Inspect all the parts and cast iron |
| body for shipping damage. Contact your dealer if |
| any irregularities are noticed. |
3. | All safety warnings have been read and followed. |
4. | This Owner’s Manual has been read. |
5. Floor protection requirements have been met.
6. Chimney connector is properly installed.
7. | The proper clearances from the stove and chimney |
| to combustible materials have been met. |
8. | The masonry chimney is inspected by a profes- |
| sional and is clean, or the factory built metal chim- |
| ney is installed according to the manufacturer’s |
| instructions and clearances. |
9. | The chimney meets the required minimum height. |
10. All labels have been removed from the glass
doors.
11.Plated surfaces have been wiped clean.
WARNING!
DO NOT TILT THE UNIT ON THE CAST IRON LEGS. Lift the unit upright and place it into position on the floor protector.
TABLE OF CONTENTS |
|
SERIAL NUMBER LABEL LOCATION | 2 |
3 | |
LISTINGS & SAFETY NOTICES | 4 |
INSTALLATIONS MATERIAL NEEDED FOR SAFETY 4 | |
DIMENSIONS & VENT SPECIFICATIONS | 5 |
CLEARANCES |
|
Top & rear vent installations | 6 |
Floor protection | |
INSTALLATION |
|
TABLE OF CONTENTS (Cont'd)
Chimney connector | 11 |
Masonry chimney | 12 |
Solid pack chimney with Metal supports |
|
as a thimble | |
Masonry fireplace | 14 |
Metal prefabricated chimney | 15 |
Mobile home installation | 16 |
Outside air kit installation | 17 |
Blower installation | 17 |
OPERATION |
|
18 | |
Burning process | 18 |
Air controls | 19 |
Heat output setting | 20 |
Building a fire | 20 |
Correct baffle & blanket placement | 21 |
Opacity | 22 |
Burn rates | 22 |
Wood selection and storage | 22 |
Blower operating instructions | 22 |
MAINTENANCE |
|
Creosote formation & removal | 23 |
Chimney cleaning | 23 |
Ash removal | 23 |
Glass care & replacement | |
Care & cleaning of plated surfaces | 24 |
Door handle assembly & door gasket | 24 |
Brick replacement | 25 |
Baffle removal & installation | 25 |
Service & Maintenance Log | 26 |
EXPLODED VIEWS | 27 |
SERVICE PARTS | 28 |
WARRANTY | 30 |
CONTACT INFORMATION | 32 |
Locating your stove | 9 |
Leg leveling system | 9 |
Side door locking mechanism | 9 |
Reversible flue collar | 10 |
Horizontal heat shield | 10 |
Chimney height requirements & Draft | 11 |
11 | |
Flue systems | 11 |
Page 3 |