Fan Installation
•Insert the 3 prong plug from the fan into the receptacle located in the AUX300 module. See Figure 6.
•Insert 3 prong plug from AUX300 module into REM/AUX receptacle of fireplace junction box.
AUX 300 MODULE
FAN CORD
Figure 6. Plug Fan into AUX300 Module
Programming the RC300 to the Control Module
CAUTION! Risk of burns! DO NOT program the remote control to the control module when fireplace is hot.
•Verify the ON/OFF/REMOTE switch is in the REMOTE position. Green LED light will blink three times and wall switch will beep once 5 seconds later when ready. See Figure 7.
•Using a small item (such as a paper clip) press and release the LEARN button located near the ON/OFF/ REMOTE switch. See Figure 7.
•Control module will beep once and LED will blink green for 10 seconds.
•While the LED is blinking, press the POWER button on the remote control. A double beep will come out of the control module to indicate that it has been programmed successfully.
NOTICE: Up to three remote controls can be programmed into the control module. Simply press a button on the other remote controls during the 10 second programming process to add another remote into the system. It is recommended to program only one RC300 remote control.
To clear memory in the control module, use a small item (such as a paper clip) to press and release the LEARN button. Control module will beep once and LED will blink green for 10 seconds DO NOT press any buttons on the remote during the ten seconds that the green LED blinks. The memory will be cleared. Note that the RC300 will not be programmed if it’s in STANDBY mode. Press the ON/ OFF button twice to switch to IDLE mode.
REMOTE POSITION
Figure 7. Programming RC300
Hearth & Home Technologies • RC300 Multifunction Remote Control • | 3 |