Hearth and Home Technologies SC60 owner manual Chimney Requirements, Height of Chimney Components

A. Chimney Requirements

Measure vertical distances from the base of the fireplace as shown in Figure 8.2.

•	Minimum overall straight height	13.5 ft	4.11 m
•	Minimum height with offset/return	14.8	4.51 m
• Maximum height		90 ft	27.43 m
• Maximum allowed shift between an offset and		4.2 ft	1.28 m
	return
• Maximum chimney length between an offset/		20 ft	6.10 m
	return
• Maximum distance between chimney		35 ft	10.67 m
	stabilizers
• Double offset/return minimum height		20 ft	6.10 m
• Maximum unsupported chimney length		6 ft	1.83 m
	between offset and return
• Maximum straight unsupported chimney height		35 ft	10.67 m
	above the fireplace
• Maximum unsupported chimney above roof		6 ft	1.83 m

WARNING! Risk of Fire! You must maintain 2 in. (51

mm)air space clearance to insulation and other combus- tible materials around the chimney system. Failure to do so may cause overheating and fire.

Table 8.1

HEIGHT OF CHIMNEY COMPONENTS		in.	mm
Chimney Stabilizer
	SL3	4-3/4	121
Ceiling Firestops
	FS338	0	0
	FS339	0	0
	FS340	0	0
Offsets/Returns
	SL315	13-3/8	340
	SL330	15-1/2	394
Roof Flashing
	RF370	0	0
	RF371	0	0
Chimney Sections*
	SL306	4-3/4	121
	SL312	10-3/4	273
	SL318	16-3/4	425
	SL324	22-3/4	578
	SL336	34-3/4	883
	SL348	46-3/4	1187
* Dimensions reflect effective height.

Determine the chimney components needed to complete your particular installation:

•Measure the total vertical height of the fireplace installation from the base of the fireplace assembly to the approximate location of the bottom of the termination cap.

•Subtract the effective height of the fireplace assembly (see Figure 8.2) from the total vertical height to determine the overall height of the chimney installation.

•Create a schematic for your application similar to Figure 8.2 showing components required (referring to Table 8.1). Figure 8.1 identifies those components and where used.

•Install a ceiling firestop whenever the chimney penetrates a floor/ceiling.

NOTICE: A maximum of two pairs of offsets and returns may be used.

CAUTION! Risk of Fire and/or Asphyxiation! DO NOT connect this fireplace to a chimney flue servicing another appliance. DO NOT connect to any air distribu- tion duct or system. These actions could cause over- heating/fire in the chimney flue, or release of exhaust fumes into the living areas.

6 ft (1.83 m) max. unsupported chimney above roof

20 ft (6.10 m) max. pipe between an offset & return

	35 ft (10.7 m)
Ceiling Firestop	max. straight
	unsupported
	chimney height
40 in.	14.8 ft (4.51 m) min. height/single offset-return
	20 ft. (6.10 m) min. height/double offset-return
(1016 mm)
	90 ft (27.4 m) max. height
Effective
Height

Figure 8.2 Chimney Requirements

Heatilator • SC60 • 32838 • Rev Y • 11/08 WIP 25