Hearth and Home Technologies WSK300 operating instructions Wall Control, Button & Display Key

Wall Control - WSK300

Control Specifications

Wall Control

4(%2-/34!4 /&& /.

-/$% MODE display section

3%4%2//- 4%-0 &! .

&,!-%!3):% (%!4 /54054

LOSS OF SIGNAL indicator

&

#



Temperature/Heat output display section

	0),/4	PILOT display section
-).	/.	TIMER display section
6%.4 -/$%
		AUXILIARY function
		level indicator
0),/4	!58	4)-%2

Button & Display Key

-/$%

0),/4

!58

4)-%2

Use MODE button to toggle through three mode functions “THERMOSTAT”, “ON”, and “OFF”. The THERMOSTAT and ON functions will be highlighted in yellow and OFF in red when selected.

-THERMOSTAT function controls the fireplace based on a desired set point.

-ON function allows the user to operate the fireplace and auxiliary features independently as desired.

-OFF function, all settings for the product are OFF.

Use PILOT button to toggle between two pilot functions. “PILOT ON” will always be highlighted on display for cold climate pilot operation. “PILOT OFF” will be displayed when in normal pilot operation for three seconds.

Use AUX button to toggle between A1, A2 and A3. Use the up and down arrows to control the level of each Auxiliary function.

Use TIMER button to set timer function for a countdown operation in “Manual” or “Auto” mode.

Use UP & DOWN ARROW button to set values within a function.

Note: Batteries should not be stored in the battery holder under the fireplace. The battery life will be shortened by the heat.

5