Heat & Glo LifeStyle 6000GL-IPILP-R Termination Locations, A. Vent Termination Minimum Clearances

6 Termination Locations

A. Vent Termination Minimum Clearances

WARNING

Fire Risk.

Maintain vent clearance to combustibles as specified.

• DO NOT pack air space with insulation or other materials.

Failure to keep insulation or other materials away from vent pipe may cause overheating and fire.

		HORIZONTAL
		OVERHANG
2 FT.	20 INCHES MIN.	VERTICAL
MIN.
		WALL
	LOWEST
	DISCHARGE
	OPENING
GAS DIRECT VENT
TERMINATION CAP
		X
		12
		ROOF PITCH
		IS X/ 12
	H (MIN.) - MINIMUM HEIGHT FROM ROOF
	TO LOWEST DISCHARGE OPENING
Roof Pitch		H (Min.) Ft.
Flat to 6/12...........................................................1.0*
Over 6/12 to 7/12.................................................1.25*
Over 7/12 to 8/12.................................................1.5*
Over 8/12 to 9/12.................................................2.0*
Over 9/12 to 10/12...............................................2.5
Over 10/12 to 11/12 .............................................3.25
Over 11/12 to 12/12 .............................................4.0
Over 12/12 to 14/12.............................................5.0
Over 14/12 to 16/12.............................................6.0
Over 16/12 to 18/12.............................................7.0
Over 18/12 to 20/12.............................................7.5
Over 20/12 to 21/12.............................................8.0
* 3 foot minimum in snow regions
Figure 6.1 Minimum Height From Roof To Lowest Discharge
Opening

A	B
6 in. (minimum) up to 20 in.	18 in. minimum
152 mm/508 mm	457 mm
20 in. and over	0 in. minimum

Gas, Wood or Fuel Oil

Termination Cap

B

A*

Gas

Termination

Cap **

*If using decorative cap cover(s), this distance may need to be increased. Refer to the installation instructions supplied with the decorative cap cover.

**In a staggered installation with both gas and wood terminations, the wood termination cap must be higher than the gas termination cap.

Figure 6.2 Staggered Termination Caps

Heat & Glo • 6000GL-IPI-R, 6000GL-IPI-S • 2102-900 Rev. R • 6/09 21