Heat & Glo LifeStyle 6000GL-IPILP-S, 6000GL-IPI-S Log Assembly: LOGS-6000GL, 5 26 1 3, Step, Hump

G. Install the Log Assembly Log Assembly: LOGS-6000GL

If the gas logs have been factory installed they should not need to be positioned. If the logs have been packaged separately, refer to the following instructions.

STEP 1.

CAUTION: Logs are fragile! Carefully remove the logs, grate and supporting cardboard from the inside of the fireplace See Figure 14.5.

STEP 2.

Place the metal grate on top of the burner. Position the legs of the grate into the forward set of indentations in the burner top. The grate should not cover any ports in the burner.

5

26

1

3 4

Figure 14.5

1

1

HUMP

Figure 14.6 Front View Figure 14.7 Top View

STEP 3. Log #1 (SRV2102-010):Log #1 is the back burning log. The air shutter in the end of the burner tube goes over the brass orifice located behind the main burner. The log should be parallel to back refractory.

2

2

Figure 14.8 Front View Figure 14.9 Top View

STEP 4. Log #2 (SRV2102-101):Place log #2 on top of log #1. The bottom side of this log has a slot in it that goes over the left metal tab sticking up out of the top of log #1. The left end of this log sits on the burner surface.

2102-910

54 Heat & Glo • 6000GL-IPI-R, 6000GL-IPI-S • 2102-900 Rev. R • 6/09