NOTICE: Once the seal cap has been removed it CANNOT be reattached.
Figure 9.7 To attach the first section of vent pipe, make sure to use the fiberglass gasket in the manual bag to seal between the first vent component and the outer fireplace wrap. Use 2 self tapping screws to secure the gasket to the outer wrap.
Secure the first section of venting to the fireplace by screw- ing through the two straps left over from cutting the seal cap strap in step 2.
B. Rear Vent
CAUTION! Risk of Cuts, Abrasions or Flying Debris. Wear protective gloves and safety glasses during instal- lation. Sheet metal edges are sharp.
NOTICE: Once appliance is set up for top or rear venting, it CANNOT be changed at a later time.
Figure 9.8 Fold the tabs toward the center of the seal cap (90º) and remove the insulation gasket.
Figure 9.10 Fold the center parts of the retaining band out and use to remove the seal cap.
Figure 9.11 Discard the vent cap, remove and discard the insulation basket.
Figure 9.9 Cut the metal retaining band and fold the sides out.
Figure 9.12 Attach the first vent section (it will snap into place). Slide the insulation gasket onto the vent section, up against the appliance and over the tabs.
Heat & Glo • | 37 |
