Heat & Glo LifeStyle 6000TR-OAK-IPI Intermittent Pilot Ignition IPI Wiring, Î3 Volt Transformer

						I	INTERMITTENT
PLUG-IN				IGNITION MODULE			PILOT
				3 VAC			IGNITOR
3V TRANSFORMER
ON/OFF						S
WALL
SWITCH
		FLAME SPARKER/
		SENSOR
IGNITION
MODULE
(3V)
						WHT
						ORG
VALVE	LOW VOLTAGE					GROUND TO
	SEE NOTE 1					FIREPLACE
						CHASSIS
GROUND		REMOTE
NEUTRAL		CONTROL	HOT			BRN
					BRN
		WHITE WIRE
		CAN BE				ORG
		PLUGGED
		INTO ANY					GRN
BLACK WIRE CAN BE		OF #1-#5
PLUGGED INTO ANY OF		LOCATIONS			PIGGYBACK
#1 - #5 LOCATIONS		ON THE			ON/OFF SWITCH
ON THE HOT SIDE		NEUTRAL SIDE		TRANSFORMER
				3 VAC
			PLUG IN
						VALVE
Figure 37. Intermittent Pilot Ignition (IPI) Wiring Diagram

Intermittent Pilot Ignition (IPI) Wiring

Î3 Volt Transformer

This appliance comes with a 3 volt transformer. The trans- former plugs into the junction box and the two leads plug into the green control module (see Figure 37).

Appliance Requirements

This appliance requires that 110-120 VAC be wired to the factory installed junction box. Maintain correct polarity when wiring the junction box.

!WARNING: DO NOT CONNECT 110-120 VAC TO THE GAS CONTROL VALVE OR THE AP- PLIANCE WILL MALFUNCTION AND THE VALVE WILL BE DESTROYED.

Operation using Battery Power

This fireplace has an optional battery operation. The sys- tem is fully functional with the use of two “D” size batteries without ordinary 110-120 VAC power.

Wiring to the battery pack should be left disconnected in order to conserve battery life. In the case of a loss of power,

simply connect red and black wire leads to activate battery power (connect red to red, black to black). The fireplace can be used as necessary. Once power (110 VAC) is re- stored, disconnect red and black wire leads to extend bat- tery life.

Optional Accessories

Optional remote control kits require that 110-120 VAC be wired to the factory installed junction box before the fire- place is permanently installed.

Wall Switch

Position the wall switch in the desired position on a wall. Run a maximum of 25 feet (7.8 m) or less length of 18 A.W.G. minimum wire and connect it to the fireplace ON/ OFF switch pigtails.

!WARNING: DO NOT CONNECT 110-120 VAC TO THE WALL SWITCH OR THE CONTROL VALVE WILL BE DESTROYED.

CAUTION: LABEL ALL WIRES PRIOR TO DISCONNEC- TION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE IMPROPER AND DANGEROUS OPERA- TION. VERIFY PROPER OPERATION AFTER SERVICING.

Heat & Glo • 6000TR-OAK, 6000TR-OAK-IPI • 383-901 Rev. K • 5/06 31