Heat & Glo LifeStyle 6000TR-OAK-IPI owner manual Installing Trim, Logs, and Ember Material

Step 11. Installing Trim, Logs, and Ember Material

Installing the Trim

Combustible materials may be brought up to the specified clearances on the side and top front edges of the fireplace, but MUST NEVER overlap onto the front face. The joints between the finished wall and the fireplace top and sides can only be sealed with a 300° F. (149° C) minimum sealant.

!WARNING: WHEN FINISHING THE FIREPLACE, NEVER OBSTRUCT OR MODIFY THE AIR INLET/ OUTLET GRILLES IN ANY MANNER.

Install optional marble and brass trim surround kits as desired. Marble, brass, brick, tile, or other non-combustible materials can be used to cover up the gap between the sheet rock and the fireplace.

Do not obstruct or modify the air inlet/outlet grilles. When overlapping on both sides, leave enough space so that the bottom grille can be lowered and the trim door removed.

RETAINING

SCREW

(BOTH SIDES)

BURNER

Figure 40.

Burner Removal

Shutter Settings

	NG	LP
___________________________________________
Burner	1/8”	5/8”

Positioning the Logs

If the gas logs have been factory installed they should not need to be positioned. If the logs have been packaged separately, refer to the instructions that accompany the logs. Save the log instructions with this manual.

If sooting occurs, the logs might need to be repositioned slightly to avoid excessive flame impingement.

Placing the Ember Material

Ember material is shipped with this gas fireplace. To place the ember material:

•Pull the four glass latches out of the groove on the glass frame. Remove glass door from the unit (see Figure 41).

LATCHES

(BOTH BOTTOM

AND TOP)

GLASS

Figure 41. ASSEMBLY

Glass Assembly

•Embers CANNOT be placed directly over ports. Care should be taken not to cover the lighting trail of ports (from back to front).

•When placing Glowing embers onto the burner care should be taken so that the ports are not covered. Place the embers along side the port trail, but not on or in between the ports (see Figure 42). Failure to follow this procedure will likely cause lighting and sooting problems.

•Place Mystic embers on areas of base refractory away from port holes. Use this material to give your fireplace a realistic ash bed.

•Save the remaining ember materials for use during fire- place servicing.

•Replace the glass door and a front trim door on the unit.

•Pull out and latch the glass clips into the groove on the glass frame.

EMBER MATERIAL

Figure 42. Placement of the Ember Material

Glass Specifications:

6000TR-OAK: TEMPERED

6000TR-OAK-IPI: TEMPERED

Heat & Glo fireplaces manufactured with tempered glass may be installed in hazardous locations such as bathtub enclosures as defined by the CPSC. The tempered glass has been tested and certified to the requirements of ANSI Z97.1-1984 and CPSC 16 CFR 1202. (Safety Glazing Certi- fication Council SGCC # 1595 and 1597. Architectural Test- ing, Inc. Reports 02-31919.01 and 02-31917.01.)

Heat & Glo • 6000TR-OAK, 6000TR-OAK-IPI • 383-901 Rev. K • 5/06 33