Heat & Glo LifeStyle EM-415 - 36, EM-485T - 42 Sidewalls/Surrounds, Frame the Fireplace

C. Sidewalls/Surrounds

•Adjacent combustible sidewalls must be located a minimum of 12 in. (305 mm) (may be 24 in) from the fireplace opening.

•Combustible and non-combustible mantel legs, surrounds and stub walls may be constructed per Figure 6.3.

10 3/4 in.

[273 mm]

Grid represents 1 in. scale

FLUSH	BRICK
FRONT	FRONT

		A
	angle
50°				39°
					angle
		B
	12 in.			12 in.
[305 mm]			[305 mm]

			A	B
			Fireplace	Outside
4 in.	Model #		Opening	Dimensions
	EM-415	in.	36	42
[102 mm]
		mm	914	1067
	EM-485	in.	42	48
		mm	1067	1219

9 3/4 in.

[248 mm]

Figure 6.3 Mantel Leg or Wall Projections (Acceptable on both sides of opening)

D. Frame the Fireplace

Figure 6.4 shows typical framing using combustible materials (2x4 lumber shown).

•Observe all required air space clearances to combustible materials as shown in Figure 6.2.

•Framing across the top of fireplace must be above top standoffs.

2 in. (51 mm) min. air space clearance

from chimney.

C

B

D A

Header MUST NOT be notched!

D = extra space needed for outside air connection.

If outside air duct has no bend, this dimension may be reduced as long as minimum clearances are met.

Model #		A	B*		C**	D
EM-415	in.		43	23	41 1/2	8
	mm		1092	584	1054	203
EM-485	in.		49	23	41 1/2	8
	mm		1245	584	1054	203

*If interior of chase will be drywalled, add the thickness to this measurement. ** Adjust header height for a raised floor under fireplace.

Figure 6.4 Framing the Fireplace

20 Heat & Glo • EM-415, EM-485 • 33056 • Rev AF• 7/12