2.2SAFETY INFORMATION
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLO- SION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.
A.This appliance has a pilot. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
C.Use only your hand to push in or turn the gas con- trol knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it. Call a quali- fied service technician. Forced or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been un- der water. Immediately call a qualified service tech- nician to inspect the appliance and to replace any part of the gas control system which has been un- der water.
2.3LIGHTING INSTRUCTIONS
LIGHTING INSTRUCTIONS
1."STOP!" Read the safety information.
2.To access controls, rotate the bottom grille down.
3.Turn the valve control knob to the "OFF" position. To
do this, you must turn the knob clockwise
to the "Pilot" position, and then press in and continue
turning clockwise | to the "OFF" position. |
GAS CONTROL VALVE
NOTE: Knob cannot be turned from "PILOT" to "OFF" unless knob is pushed in slightly. Do not force.
4.WAIT FIVE (5) MINUTES TO CLEAR OUT ANY GAS. Then smell for gas, including near the floor. If you then smell gas, STOP! Follow "B" in the safety information above. If you don't smell gas, go to the next step.
5.The pilot should not require accessing for lighting purposes. The pilot is located inside the combustion chamber.
THERMOPILEPILOTBURNER
6. To put the control in the pilot position, turn the
control knob
7.To light the pilot depress the control knob and then depress the red piezo button until it makes a clicking sound. It may be necessary to repeat this step. If the pilot does not light after 10 seconds, go back to step 3. The control knob should be held down for a MINUTE after pilot ignition.
•If the control knob does not pop out when released,
•If the pilot will not stay lit after two tries, turn the control knob to the "OFF" position and call your service technician or gas supplier.
8.After the pilot has been lit, the burner can be turned on
byturning the knob 
to the "ON" position. Flip the ON/OFF switch to the "ON" position.
9.Close the bottom grille.
10.When using accessories leave rocker switch in the "OFF" position.
TO TURN OFF GAS APPLIANCE
1.Open the bottom grille.
2.Turn ON/OFF switch to "OFF".
3.Turn the valve control knob clockwise 
to the "Pilot" position, then depress knob and continue turning to "OFF" position.
4.Close the bottom grille.
25
