ASH REMOVAL SYSTEM INSTALLATION
1.Remove ash removal system top and bottom cover plates by loosening nuts under stove.
2.Discard both plates.
3.Place protective pad or stove pallet on floor.
4.Lay body of stove on its back on protec- tive pad or pallet.
5.Line up holes in ash removal system with holes in adapter on bottom of stove (see Figure 22).
6.Screw ash removal system in place.
7.Carefully stand stove up and place in desired location.
8.Open door of stove and check to insure firebricks and kaowool blanket are in their proper locations.
9.Insert ash removal system grate into opening in firebox floor.
OPERATING AND CLEANING
CAUTION: DO NOT operate stove with ash removal system door open. Ensure that embers have cooled completely before removing ash.
1.When stove is cool, open front door and brush most of the ash into the center of the firebox. Remember to leave 1/4” to 1/2”
2.Clean ash down through the ash re- moval system grate into the drawer be- low. If there are large pieces in the ashes, you can remove the grate before clean- ing the ash into the drawer. Be sure to replace the grate before operating the stove.
3.Release latch on side of ash removal door (see Figure 23).
FIGURE 22 |
FIGURE 23 |
4.Pull out the ash drawer. Close ash removal door. (Closing this door avoids ash blowing into the room in the event of a downdraft.)
5.Empty ashes into metal container. Store container on
6.Open ash removal door and replace ash drawer, making sure handle faces forward.
7.Close ash removal door and fasten latch.
18
