Heat & Glo LifeStyle WS-250, WS-150 Safety Listing, Installation Materials Needed For Your Safety

SAFETY LISTING

The WS-150 AND WS-250 are approved for mobile home installations with outside combustion air in the U.S. (See page 14 for further details). For residential installations in Canada without an outside combus- tion air kit, a source of fresh air into the room must be provided.

INSTALLATION MATERIALS NEEDED FOR YOUR SAFETY

CHIMNEY CONNECTOR (also known as flue pipe or stove pipe): The chimney connector joins the stove to the chimney (see page 11). It should be 6" (152mm) minimum diameter 24 MSG black or blued steel, or an approved air-insulated double wall venting pipe.

THIMBLE: A manufactured or site-constructed device installed in combustible walls through which the chimney connector passes to the chim- ney (see pages 11-12). It is intended to keep the walls from igniting.

CHIMNEY SYSTEMS

A.APPROVED MASONRY (see specifications on pages 12-13) with at least 5/8" (16mm) fire clay lining joined with refractory cement or other listed system suitable for use with wood stoves.

B.PREFABRICATED 6" (152mm) listed high tem- perature (UL 103HT or ULC 629M) chimney. Com- ponents required by manufacturers for installa- tion such as the chimney support base, firestop (as appropriate), attic insulation shield, insulated tee, etc., are necessary to assure a safe chim- ney installation. Use only components manufac- tured for the chimney. Chimney installation should meet NFPA 211 standards.

FIRE SAFETY: To provide reasonable fire safety, the following should be given serious consideration:

1.Install at least one smoke detector on each floor of your home to ensure your safety. They should be located away from the heating appliance and close to the sleeping areas. Follow the smoke

detector manufacturer’s placement and installa- tion instructions, and be sure to maintain regularly.

2.A conveniently located Class A fire extinguisher to contend with small fires resulting from burning embers.

3.A practiced evacuation plan, consisting of at least two escape routes.

4.A plan to deal with a chimney fire as follows: In the event of a chimney fire:

A.Notify fire department

B.Prepare occupants for immediate evacuation.

C.Close all openings into the stove.

D.While awaiting fire department, watch for ig- nition of adjacent combustibles from over- heated stove pipe, hot embers or sparks from the chimney.

VENTING SYSTEM

The venting system consists of a chimney connector and a chimney. These get extremely hot during use. In the event of a creosote fire, temperatures inside the chimney may exceed 2000°F (1100°C). To pro- tect against the possibility of a house fire, the chim- ney connector and chimney must be properly installed and maintained. An approved thimble must be used when a connection is made through a combustible wall to a chimney. A chimney support package must be used when a connection is made through the ceil- ing to a prefabricated chimney. These accessories are absolutely necessary to provide safe clearances to combustible wall and ceiling material. Follow vent- ing manufacturer’s clearances when installing vent- ing system.

This stove may be connected to a lined masonry chimney or a listed high temperature prefabricated approved metal chimney. Do not connect it to a chim- ney serving another appliance. To do so will affect the safe operation of both appliances.

7