Installation
HARDWARE
TYPE A: 11EA | TYPE B: 4EA | TYPE C: 3EA |
(SHORT SCREW) | (WOOD SCREW) | (L BACKET) |
10mm | 16mm |
|
TYPE D: 1EA | TYPE E: 1EA | TYPE F: 2EA |
(SEAL STRIP) | (SASH SEAL) | (GUIDE PANEL) |
(Adhesive backed) | (Not adhesive backed) |
|
3.2.2 BEFORE INSTALLATION
1.Insert the guide panels into the guides of the air condi- tioner. Fasten the curtains to the unit with screws (TYPE A) as shown Figure. 25.
2.Cut the
Remove the backing from the seal strip and attach the seal strip to the underside of the bottom window. (Figure. 26)
TYPE A
Figure 25
TYPE A
3.2.3 NOW START INSTALLATION
1. LOCATING UNIT IN WINDOW
Open the window and mark center line on the center of the inner sill, as shown in Figure. 27.
2.ATTACH L BRACKET
a.Install the L brackets behind the inner window sill, with the short side of bracket as shown.
Use the 2 screws (TYPE A) provided.
b.The bracket helps to hold unit securely in place. Be sure to place bracket edge flush against back of inner sill. See Figure. 27.
CAUTION
During the following step, hold unit firmly until window sash is lowered to top channel behind side panel frames. Personal injury or property damage may result if unit falls from window.
SEAL STRIP 
(TYPE D)
Figure 26
CENTER LINE
INNER SILL
ROOM SIDE
Figure 27
— 13—
