Heat Controller RAH-183G owner manual Installation Instructions Air Conditioner

Owner’s Manual Room Air Heat Pump with R-410A Heat Controller, Inc.

Installation Instructions

Air Conditioner

Question? Consumer information line (86517--756)87-21008617555(Customer Service Center)

BEFORE YOU BEGIN

Read these instructions completely and carefully.

●IMPORTANT — Save these

instructions

●IMPORTANT— Observe all governing codes and ordinances.

●Note to Installer — Be sure to leave these instructions with the Consumer.

●Note to Consumer — Keep these instructions for future reference.

●Skill level — Installation of this appliance requires basic mechanical skills.

●Completion time — Approximately 1 hour

●We recommend that two people install this product.

●Proper installation is the responsibility of the installer.

●Product failure due to improper installation is not covered under the Warranty.

ELECTRICAL REQUIREMENTS

The 3-prong grounding plug minimizes the possibility of electric shock hazard. If the wall outlet you plan to use is only a 2-prong outlet, it is your responsibility to have it replaced with a properly grounded 3-prong wall outlet.

Some models require 230/208-volt a.c., protected with a time delay fuse or circuit breaker. These models should be installed on their own single branch circuit for best performance and to prevent overloading house or apartment wiring circuits, which could cause a possible fire hazard from overheating wires.

CAUTION:

Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.

Do not change the plug on the power cord of this air conditioner.

Aluminum house wiring may present special problems —consult a qualified electrician.

Power cord includes a current interrupter

TOOLS YOU WILL NEED

device. A test and reset button is provided on

the plug case. The device should be tested on a periodic basis by first pressing the TEST button and then the RESET button. If the TEST button does not trip or ifAdjustablethe RESETwrenchbutton will not stay engaged, discontinue use of the air conditioner and contact a qualified service technician.

TOOLSPhillips headYOUscrewdriverWILL NEEDFlat-blade screwdriver

Pencil Adjustable wrenchRuler or tape measure

Level	Scissors or knife
Phillips head screwdriver	Flat-headbladescrewdiverriv

Power cord includes a current interrupter
device. A test and reset button is provided on
Pencil	Ruler or tape measure

periodic basis by first pressing the TEST button and then the RESET button. If the TEST button

does RESET button will not stay

engaged, discontinue use of the air conditioner
Level	service Scissors or knife

6