Dated receipt required for warranty replacement.
Features
•Automatically comes on when motion is detected.
•Automatically turns light off.
•Photocell keeps the light off during daylight hours.
•LED indicates motion was sensed (day or night).
Requirements
•The light control requires 120 volts AC.
•If you want to use Manual Override mode, the control must be wired through a switch.
NOTICE: Not to be used on light dimmer or timer- controlled circuits.
•Some electrical codes require installation by a qualified electrician.
•This product is intended for use with the enclosed gasket and with a junction box marked for use in wet locations.
•This light fixture has been tested/certified using Lights of America LED Lamp Model Numbers
Unpacking
Be sure to remove all contents from packaging and verify all items are present before assembling this light fixture. This package includes the following items:
•Security Light
•Two LED PAR38 lamps
(Lights of America Model:
•Two decorative lamp shells
•Mounting Strap
•Plastic Hanger
•Rubber Plug
•Mounting hardware
•Wire nuts
•Owner’s Manual
Motion Sensor
Light Control
Model: 9700LED Series
INSTALLATION
For easy installation, select an existing light with a wall switch for replacement.
For best performance, mount the fixture about 8 ft. (2.4 m) above the ground.NOTE: If fixture is mounted higher than 8 ft. (2.4 m), aiming the sensor down will reduce coverage distance.
eave Mount Wall Mount
For under eave installation,the sensor head must be rotated as shown in the next two steps for proper operation and to avoid the risk of electrical shock.
For eave mount only:
1.Swing the sensor head towards the clamp screw joint.
Controls
Clamp Screw
2.Then rotate the sensor head clockwise 180° so the controls face down.
Controls
Controls
If the sensor pops out of the ball joint, loosen the clamp screw and push the sensor back into the ball joint. Tighten the clamp screw when done.
© 2008 |
