TROUBLESHOOTING GUIDE
SYMPTOM | POSSIBLE CAUSE | SOLUTION | ||
|
|
|
|
|
|
|
|
|
|
Lights will not come | 1. | Light switch is turned off. | 1. | Turn light switch on. |
on. | 2. | Lamp is loose or burned out. | 2. | Check lamp and replace if burned out. |
| 3. | Fuse is blown or circuit breaker is turned | 3. | Replace fuse or turn circuit breaker on. |
|
| off. |
|
|
| 4. | Daylight | 4. | Recheck after dark. |
| 5. | Incorrect circuit wiring, if this is a new | 5. | Verify wiring is correct. |
|
| installation. |
|
|
| 6. | Sensor is not aimed toward desired cover- | 6. | |
|
| age area. |
|
|
|
|
|
|
|
Lights come on in | 1. | Light control may be installed in a relatively | 1. | The fixture is operating normally under these |
daylight. |
| dark location. |
| conditions. |
| 2. | Light control is in TEST. | 2. | Set control switch to 1, 5, or 10 minutes. |
|
|
|
|
|
Lights come on for no | 1. | Light control may be sensing small animals | 1. | Reduce Range. |
apparent reason. |
| or automobile traffic. |
|
|
| 2. | Range is set too high. | 2. | Reduce Range. |
|
|
|
|
|
Lights stay on | 1. | The sensor may be picking up a heat source | 1. | Reduce Range. |
continuously. |
| like an air vent, dryer vent, or brightly |
|
|
|
| painted, |
|
|
| 2. | Sensor is in Manual Override mode. | 2. | Set control switch to 1, 5, or 10 minutes. |
|
|
|
| Follow manual override instructions to reset. |
|
|
|
|
|
Lights flash on and | 1. | Heat or light from the lamps may be turning | 1. | Reposition the lamps away from the sensor. |
off. |
| the light control on and off. |
|
|
| 2. | Heat being reflected from other objects | 2. | Reduce Range. |
|
| may be affecting the sensor. |
|
|
| 3. | Sensor is in the Test mode. | 3. | While in TEST mode, light only stays on for 5 |
|
|
|
| seconds. |
| 4. | Light may be leaking through the flood | 4. | Make sure the metal lamp protectors are in- |
|
| lamp reflectors |
| stalled. |
|
|
|
|
|
5 |