Heath Zenith SH-5511 manual Specifications, Troubleshooting Guide

SPECIFICATIONS

Range . . . . . . . Up to 60 ft. (18.3 m) [varies with surrounding temperature].

Sensing Angle. . . . Up to 110°

Electrical Load. . . . Up to 150Watts Maximum tung- sten

Power Requirements. 120 VAC, 60 Hz

Operating Modes. . . TEST, AUTO and MANUAL

MODE

Time Delay . . . . . 1, 5, 10 minutes Range . . . . . . . Adjustable

Replacement lamp. . T 150W (or less) halogen 120

VAC

HeathCo LLC reserves the right to discontinue prod- ucts and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.

TROUBLESHOOTING GUIDE

SYMPTOM	POSSIBLE CAUSE
Light will not	1.	Light switch is turned off.
come on.	2. Halogen lamp is loose or burned
		out.
	3.	Fuse is blown or circuit breaker is
		turned off.
	4.	Daylight turn-off is in effect (Recheck
		after dark).
	5.	Incorrect circuit wiring, if this is a new
		installation.
	6.	Not aimed correctly (Re-aim the
		sensor to cover desired area).
Light comes on	1. Light control may be installed in a
in daylight.		relatively dark location.
	2.	Light control is in TEST (Select 1, 5
		or 10 minutes for AUTO time).
Light comes on	1. Light control may be sensing small
for no apparent		animals or automobile traffic (re-aim
reason.		sensor).
	2.	Sensitivity is set too high (Reduce
		sensitivity).

SYMPTOM	POSSIBLE CAUSE
Light stays on	1. The halogen lamp is positioned too
continuously.		close to the light control's sensor or
		pointed at nearby objects that cause
		heat to trigger the sensor (Reposition
		the lamp away from the sensor or
		nearby objects).
	2.	Lightcontrol'ssensorispointedtoward
		a heat source like an air vent, dryer
		vent,orbrightly-paintedheat-reflective
		surface (Reposition sensor).
	3.	Light control is in Manual Mode.
		(Switch to Auto.)
Light flashes	1.	Heat or light from the halogen lamp
on and off.		may be turning the light control on
		and off (Reposition the lamp away
		from the sensor).
	2.	Heat being reflected from other
		objects may be affecting the light
		control (Re-aim sensor).
	3.	Light control is in the TEST mode
		and warming up (Flashing is normal
		under these conditions).

598-1159-06