Heath Zenith manual Compact 150 Watt Motion Sensing Halogen, Operation, Model SL-5511, On-Time

Compact 150 Watt Motion Sensing Halogen

Model SL-5511

The Motion Sensor Quartz Security Light turns on 150 watts of quartz-halogen lighting when motion is detected and then, after a selectable period of time, automati- cally turns the lighting off. The built-in photocell keeps the lighting off during daylight hours.

This package includes:

OPERATION

Mode:	On-Time	Works: Day	Night
Test	5 Seconds	x	x
Auto	1, 5, or 10 Min		x
Manual	Until Dawn*		x

* resets to Auto Mode at dawn.

Note: When first turned on wait about 11/2 minutes for the circuitry to calibrate.

TEST

Put the ON-TIME switch on the bottom	ON-TIME
of the sensor in the TEST position.
	10 5 1 TEST
AUTO
Put the ON-TIME switch in the 1, 5,	ON-TIME
or 10 minute position.
	10 5 1 TEST
MANUAL MODE

	Cover Plate
	Gasket
	Cover
	Plate
	4 Screws
	(2 sizes)
	Halogen
	Bulb
	Sensor
Light Fixture	3 Wire

Manual mode only works at night because daylight returns the sensor to AUTO.

Flip the light switch off for one second then back on to toggle between AUTO and MANUAL MODE.

Manual mode works only with the ON-TIME switch in the 1, 5, or 10 position.

1 Second OFF

then...

... back on.

Connectors

Requirements

•The light control requires 120-volts AC. Do not con- nect through a dimmer or other electronic switch.

•If you want to use Manual Mode, the control must be wired through a switch.

•Some codes require installation by a qualified electrician.

•This product is intended for use with the enclosed gasket and with a junction box marked for use in wet locations.

•The backplate has knockouts so the sensor can be mounted on most junction boxes.

•In some applications a universal adaptor plate may be needed. Adaptors are available at Home Centers and Electrical Supply Stores.

Mode Switching Summary

	TEST	Move ON-TIME Switch
		to 1, 5, or 10 minutes
	AUTO		Flip switch off for
			one second then
			back on*
MANUAL MODE

*If you get confused while switching modes, turn the power off for one minute, then back on. After the calibration time (11/2 min.) the control will be in the AUTO mode.

© 2007 HeathCo LLC 595-5574-06