Sony 900, 930, 950 manual +5 V indicator, Operation switch, Mode switch 0 Factory setting, Contents

7 7-6-2Internal Board

+5	OPERATION	MODE	CHARACTER SYNC
	NORMAL EMERGENCY	UP DOWN SET CANCEL PHUSE OFF ON

1 +5 V indicator	3 MODE switch	6 SYNC ON/OFF
2 OPERATION switch	4 UP/DOWN switch	switch
		7 CHARACTER
	5 SET/CANCEL switch
		PHASE control

a+5 V indicator

Lights when +5 V power to the board.

bOPERATION switch

NORMAL: Set to this position for normal operation.

EMERGENCY: Set to this position when the CNU-500 or MSU-700 cannot function normally. The RCP-700 Series Remote Control Panels are directly connected to their respective camera control units.

The switch is set to NORMAL at the factory.

cMODE switch 0: Factory setting

1: When the switch is set to this position, the UP/DOWN switch is activated, and the switch changes the character page displayed on a monitor connected to the CHARACTER connector.

2 through F: Not used.

dUP/DOWN switch

Changes the page displayed on the monitor screen. This switch functions only when the MODE switch is set to 1. The contents of each page are shown in the following table.

Page	Contents
	Nothing appears when power is turned on.
1	Shows a warning if a problem is detected by
	the self-diagnosis of the camera.
2	Connection status of Cameras 1 through 6.
3	Not used.
4	Not used.
5	Shows the results of auto set-up of Camera 1
	through 6.
6	Cannot be used.
	DIAGNOSIS OF ALL CAMERAS displays,
7	which shows the results of the self-diagnosis
	of all the cameras.
8	Not used.
	DIAGNOSIS OF ONE CAMERA display, which
9	shows the results of the self-diagnosis of the
	selected camera.
10	DATA OF ALL CAMERAS display, which
	shows the setting status of each camera.
11	DATA OF ONE CAMERA display, which shows
	the setting status of the selected camera.

eSET/CANCEL switch

Selects the displayed item or camera (CAM) when display page 9, 10 or 11 appears on the monitor screen.

fSYNC ON/OFF switch

Selects whether the sync signal is to be added to the video signal output from the CHARACTER connector. At the factory, the switch is set to ON (added).

gCHARACTER PHASE control

Adjusts the horizontal phase of the signal output from the CHARACTER connector, referring to the reference signal. Adjust the phase by monitoring the signal on the monitor screen.

HDC-900/950/930 Series Product Information Manual Chapter 7 Location and Function of Parts and Controls 104