Sony 950, 930, 900 manual Audio in audio input 1, 2 connectors BNC type and switches

7	e TRACKER connector (20-pin)
	Used for communication between the camera operator
	and tracker and for intercom 1 and 2 connection. This

also supplied the up tally and program audio signals. The TRUNK LINE input/output signals are also assigned.

f GENLOCK IN/RET IN/PROMPTER OUT (external gen-lock signal input/return video signal input/ prompter signal output) connector (BNC type) and switch

Set the switch according to the signal at the connector. GENLOCK IN: For input of an external gen-lock signal

(valid in stand-alone use only)

RET IN: For input of the return video signal (valid in stand-alone use only)

PROMPTER OUT: Used for output of a prompter signal (valid only when a camera control unit is connected)

g AUDIO IN (audio input 1, 2) connectors (BNC type) and switches

Connect audio signals. An input select switch and microphone power switch are provided for each channel.

1 Input select switches

2 Microphone power switches

lDC IN (DC power supply input) connector (XLR 4-pin)

Used for connection to the AC-550/550CE AC Adaptor, a battery etc. to supply power to the camera.

mHD SERIAL OUT connector (BNC type) Used for output of HD SDI serial data.

nVTR connector (26-pin)

Used for connection to a VTR (such as the HDW-250) or HDCD-50 HD Signal Distributor.

LINE MIC OFF+48V LINE MIC OFF+48V

AUDIO

IN

CH-1CH-1

AInput select switch: Set to the appropriate position according to the connected equipment. LINE: When a line-level signal source is

connected

MIC: When a microphone is connected

BMicrophone power switch:

When a microphone is connected, set whether or not to supply power to the microphone. +48V: To supply a power of +48 V

OFF: Not to supply a power

Note

To supply a power of +12 V, modification of the camera is required. For details, refer to the Installation & Maintenance Manual. Note that the modification must be performed by service personnel only.

hRET CONT (return control) connector (6-pin) Used for connection to a CAC-6 Return Video Selector.

iEXT I/O (external input and output) connector

(20-pin)

Used to supply signals, such as Y/Pb/Pr signals, to external equipment.

jREMOTE connector (8-pin)

Used for connection to an RM-B150 Remote Control Unit, RCP-700-series Remote Control Panel or MSU- 700A/750 Master Setup Unit.

kDC OUT (DC power supply output) connector (4-

pin)

Used to supply power to devices such as a wireless receiver (optional).

HDC-900/950/930 Series Product Information Manual Chapter 7 Location and Function of Parts and Controls 85