7

position turns the power on, and setting it to " " turns it

on the remote control panel, this switch alone cannot

off. The indicator lights when the power supply is on.

turn on the video camera power.

 

g CAMERA POWER switch and indicator

h INTERCOM connector (XLR 5-pin)

 

Turns on or off the power to the camera when the MAIN

Connects to a headset.

 

POWER switch is on. Setting the switch to the " I"

Note

 

position turns the power on, and setting it to "O " turns

To use a headset with a plug other than an XLR 5-pin

 

it off. When a remote control panel is connected and

plug, consult a Sony service or sales representative.

 

the power supply is turned off with the CAM PW button

 

7-3-2Rear Panel

8Expansion slot

1CAMERA connector

HD signal input/output block

SD signal input/output block

2 AC IN connector

3 Remote control connectors

4 CHARACTER OUTPUT connector

5 DIGITAL AUDIO connector

6 MIC OUTPUT connectors

7 INTERCOM/TALLY/PGM connector

aCAMERA connector (optical fiber connector) Used to connect a video camera, using an optical fiber cable such as the FC2-PD50/PD250. All video camera signals, including power supply, control, video, and audio, are sent and received over one optical fiber cable.

Note

Dust on the connection surface of the optical fiber cable may result in transmission errors. When not connected, always cover the end with the supplied cap.

bAC IN (AC power supply input) connector Use the supplied power cord to connect to an AC power supply. The power cord may be secured to the HDCU-900 body using the supplied plug holder.

c Remote control connectors

1 RCP/CNU REMOTE connector

2WF REMOTE connector

 

3 TRUNK LINE connector

REMOTE

TRUNK LINE

WF

 

RCP/CNU

 

MIC

I/O PORT

 

5 I/O PORT connector

4MIC REMOTE connector

ARCP/CNU REMOTE connector (8-pin)

Used to connect to an MSU-700A/750 Master Setup Unit, CNU-500/700 Camera Command Network Unit, or RCP-700 series Remote Control Panel via a CCA-5 Connection Cable. Control signals are sent and received via this connector.

When using an RCP-700 series unit, power is also supplied.

BWF MODE REMOTE (waveform monitor remote) connector (D-sub 15-pin)

Used to attach to the appropriate connector on a waveform monitor when operating the waveform monitor display using an MSU-700A/

HDC-900/950/930 Series Product Information Manual

Chapter 7 Location and Function of Parts and Controls 88

Page 88
Image 88
Sony 950, 930, 900 2Rear Panel, Position turns the power on, and setting it to turns it, RCP/CNU Remote connector 8-pin