Sony 950, 930, 900 manual 2Setting the Security Status, MSU-700A, Operation

6	1. Turn on the power to the MSU-700A/750 while
	holding PARA, PANELACTIVE, and camera select
	buttons pressed.
	PARA button			MSU-700A
			WAVEFORM MONITOR		CC
	PARA	MULTI
	PANEL	TALLY
	ACTIVE

1 2 3 4 5 6 7 8 9 10 11

EXPAND

Camera select button 1

PANEL ACTIVE button
PARA button					MSU-750
PANEL ACTIVE
button	PANEL	PARA	EXPAND
	ACTIVE
						MULTI
						TALLY
	0 7	0 8	0 9	1 0	1 1	1 2
						MULTI
						TALLY
	0 1	0 2	0 3	0 4	0 5	0 6

Camera select button 1

The numeric keys appear on the display.

2.Press the [0] [3] [5] [9] of the numeric keys to enter "0359" in the field for entering the security code, then press [OK].

The Engineer Protection display now appears.

Engineer Protection Exit

Protection

Code

Enable

Code

Delete

3.To delete the security code, press [Code Delete]. To temporally disable the security code, press [Code Enable] to change it from inverse video to unhighlighted display. (Once you press it again to return it to inverse video, the security code is enabled.)

4.As the message "Code Delete, OK?" is displayed, if you press [Code Delete] in step 3, press [OK] to return to the Engineer Protection display.

5.Press [Exit].

Note

At the factory, the unit is set in a mode in which no security code is used.

6-3-2Setting the Security Status

You can limit the control functions of the MSU-700A/ 750 when required. The status setting is enabled in the Engineer Mode.

Operation

Proceed as follows:

Menu operation block(Example:MSU-700A)

Configuration Menu

MODE

			Configuration Menu
		Camera	CCU
	MULTI	CNU	MSU
1	CARD		2
	CONFIG

MAINTENANCE

FILE

PAINT

1.Press to light the CONFIG button.

2.Press [MSU]. The MSU Configuration Menu appears.

	MSU Configuration Exit
MSU	MSU SW
Adjusting	Set
Date /	Security
Time

3.Press [Security]. The Security Menu display appears.

Security Menu Exit

Engineer Mode

4.Press [Engineer Mode] to set it to inverse video. The numeric keys and field for entering the Code No. are displayed.

Engineer Mode

Code No:

7 8 9

4 5 6

1 2 3

0

OKCancel

HDC-900/950/930 Series Product Information Manual Chapter 6 A Quick Lesson on Camera Settings 70