Sony 930, 950 manual HDC-900, HD Color Video Camera, 1Right Side and Left Side Panels

7 7-1.HDC-900, HD Color Video Camera

7-1-1Right Side and Left Side Panels

1 Up tally lamp

2 Safety lock

3 Camera number plate 1

4Side panel lock screw

5Lens lock and knob

6 Cable clamp

8AUDIO IN CH-1 and CH-2 connectors

9AUDIO IN switch

0Microphone power switch For feture use

qa PROMPTER connector qs TEST OUT connector

Left side

7Accessory bracket

Right side

7 Accessory bracket

qh DC OUT connector

qf RET CONTROL connector qg TRACKER connector

qd REMOTE connector

	1 Up tally lamp
1	2 Safety lock
	3 Camera number plate
	4 Side panel lock screw

5 Lens lock and knob

6 Cable clamp

wa HD SERIAL OUT connector w; VTR connector

qj CCU connector qk DC IN connector ql AC OUT connector

aUp tally lamp

Lights when the camera receives a red tally signal. When the CALL button on the MSU-700A/750 Master Setup Unit or the RCP-700 series Remote Control Panel is pressed, the lamp lights if previously off or goes off if previously on. The brightness of the lamp may be adjusted using the menu. Setting the UP TALLY switch on the rear panel to OFF will keep the lamp from lighting. Attach a supplied number plate (0 through 9) to display the camera number.

bSafety lock

Locks the side panel to prevent accidental opening. To open the side panel, loosen the side panel lock screws, slide the safety lock toward the lens and open the panel. The side panel locks automatically when closed.

cCamera number plate

Attach a light gray number plate (supplied) to display the camera number.

dSide panel lock screws

These screws secure the side panel. Turn clockwise until tight to lock the panel.

eLens lock and knob

These lock the lens. To attach or remove a lens, turn the knob counterclockwise until the lens lock is horizontal. To secure the lens, turn the knob clockwise until the lens lock is vertical.

Note

To attach a large lens, remove the pin from the bayonet mount of the lens.

HDC-900/950/930 Series Product Information Manual Chapter 7 Location and Function of Parts and Controls 77