Sony 930 Cable clamp, Accessory bracket, Microphone power switches, Prompter connector BNC type

7	f Cable clamp
	Used to secure the fiber optic cable. The clamp is
	designed for the FC2-PD50 and FC2-PD250.

g Accessory bracket

Used to secure optional accessories such as the BKP- 7911/7912 Script Holder or Focus/Zoom Demand.

For more information on attaching an accessory, see the accessory’s operation manual.

h AUDIO IN CH-1 and CH-2 connectors (XLR 3-pin) Used to input microphone or line signals.

i AUDIO IN switch

Set this switch according to the device connected to the AUDIO IN CH-1 and CH-2 connectors.

MIC: When connecting microphones

LINE: When connecting line signal sources

j Microphone power switches

For the microphones connected to the AUDIO IN CH- 1 and CH-2 connectors, respectively.

+48 V: When the connected microphone requires an external power source. A power of +48 V is supplied to the microphone.

OFF: When the connected microphone requires no external power.

Note

To supply a power of +12 V, modification of the camera is required. For details, refer to the Installation & Maintenance Manual. Note that the modification must be performed by service personnel.

k PROMPTER connector (BNC type)

Used to output the signal input from the HDCU-900

Camera Control Unit’s PROMPTER INPUT connector.

l TEST OUT (test signal output) connector (BNC type)

Used to output the signal selected by the video signal select buttons on the rear panel. If the RET 1 or RET 2 button is pushed in, the output will be a return video signal.

m REMOTE connector (8-pin)

Used to connect the camera to an optional MSU-700A/ 750 Master Setup Unit or RCP-700 series Remote Control Panel, via a CCA cable. The connected unit may then control the HDC-900.

n TRACKER connector (20-pin)

Used for communication between the camera operator and the tracker, and also for intercom channels 1 and 2. It also supplies the up tally signal and the program audio signal.

o RET (return video) CONTROL connector (6-pin) This connector allows an external controller to switch return video 1, 2, and 3, as well as turn the intercom microphone on and off.

p DC OUT connector (4-pin)

Used to supply power (12 V, 5 W maximum) to a script light of the BKP-7911/7912 Script Holder.

q CCU (camera control unit) connector (electro optical multi-connector)

Connect to the CAMERA connector of the HDCU-900 Camera Control Unit using an electro-optical composite cable. Power and video, audio, and control signals are passed between the camera and the control unit using just one cable.

rDC IN connector (4-pin)

Connect to a DC power source (10.5 to 17 V) when using the HDC-900 as a stand-alone unit.

sAC OUT connector

Used to supply AC power (200 VA maximum).

tVTR connector (26-pin)

When using the camera in stand-alone use, a VTR can be connected using an HDCZ cable to this connector. In this case, however, the VTR cannot be started or stopped from the camera.

uHD SERIAL OUT connector

A serial digital interface with a transfer speed of 1.5 Gbps, this connector may be used to output a video signal to a monitor or VTR.

HDC-900/950/930 Series Product Information Manual Chapter 7 Location and Function of Parts and Controls 78