Sony 930, 950, 900 manual 1-2To change the security code, 1-3To enable to cancel the security code

6	5. Press [Code Change].
	The numeric keys and field for entering a New Code
	No. are displayed.
		Security Menu
		Code Change			Exit
		New Code	7	8	9
		Engineer Mode
		No:	4	5	6
	Status	Code
		Change
			1	2	3
		Engineer0Mode
		OK		Cancel

Note

Each digit you input will be displayed as an asterisk. Security menu items now appear.

Security Menu Exit

Engineer Mode

Status Code

Change

Engineer Mode

6.Enter the desired code (1 to 8 digits) using the numeric keys, then press [OK].

Note

Each digit you input will be displayed in an asterisk. The message "Retype New Code No." is then displayed.

7.Enter the same code you entered in step 5 once again, then press [OK].

The security menu is restored.

8.Press [Exit].

The specific security code is now registered. When you next press [Engineer Mode] on the security menu, the numeric keys appear and the code input is required. The MSU-700A/750 will enter the Engineer Mode, if you enter the code properly and press [OK].

6-3-1-2To change the security code

When the registered security code must be changed, proceed as follows.

1.Display the security menu items by following steps 1 through 3 of the above procedure for setting a new code.

2.Press [Engineer Mode].

The numeric keys and field for entering the Code No. are displayed.

Engineer Mode

Code No:

7 8 9

4 5 6

1 2 3

0

OKCancel

3.Enter the old security code using the numeric keys, then press [OK].

4.Press [Code Change].

The numeric keys and field - for entering the Old Code No. are displayed.

Code Change

Old Code No: 7 8 9

4 5 6

1 2 3

0

OKCancel

5.Enter the old code, then press [OK].

The field for entering a New Code No. now appears.

Code Change

Old Code No:	7 8 9
********

New Code

No:

4 5 6

1 2 3

0

OKCancel

6.Specify a New Code No. by following steps 6 through 8 of the previous procedure.

6-3-1-3To enable to cancel the security code

To use a security code while in the Engineer Mode, it is necessary to set the unit in a mode to use the security code. If the operator forgets the security code, or if an adjustment while in the Engineer Mode becomes necessary in an emergency when the authorized operator is absent, the security code can be canceled by the following procedure:

HDC-900/950/930 Series Product Information Manual Chapter 6 A Quick Lesson on Camera Settings 69