Sony 930, 950, 900 RM-B750, Hand-held Remote Control Unit, 13-1Operation Panel, Memory Stick slot

7 7-13.RM-B750, Hand-held Remote Control Unit

7-13-1Operation Panel

3 PANEL ACTIVE button
4 STANDARD button
	5 Spare button
	6 Test signal output select buttons
2 MEMORY STICK lamp		7 CLOSE button
1 Memory Stick slot			8 VTR START/STOP button
Rubber cap				9 VTR playback
				control buttons
PANEL STANDARD	TEST BARS	CLOSE VTR
ACTIVE			START/STOP
MEMORY
STICK
			AWB	ABB
			WHITE
MONITOR
FUNCTION			BLACK
VF DISP
MAINTENANCE
VF MENU
SCENE			IRIS/MB
CANCEL		AUTO		MASTER
		IRIS	ACTIVE
				BLACK
PAINT		EXT
ENTER
ALARM		IRIS
MENU SELECT	REMOTE CONTROL UNIT		RM-B750
qa Menu operation block				qd White balance/black
q; ALARM indicator				balance control block
			qs Iris/master black control block

aMemory Stick slot

Insert a Memory Stick to store setting data, such as reference files and scene files of the video camera or camera control unit.

bMEMORY STICK (Memory Stick access) lamp The lamp shows the status of the Memory Stick. Off: No Memory Stick is inserted.

Lit in green: There is a Memory Stick in the slot. In this condition, you can safely eject the Memory Stick.

Lit in red: Data are being read/written. If you eject the Memory Stick in this condition, the data are not guaranteed. All the data may be lost.

cPANEL ACTIVE button

Press to select the control mode for the connected camera system. Each time you press the button with the factory setting, the control mode cyclically switches among FULL, PART, and LOCK modes. FULL mode: All controls from this unit are enabled

(panel active status). Both this button and the IRIS/ MB ACTIVE indicator in the iris/master black control block light.

PART mode: Controls only from the iris/master black control block are enabled (iris/master black active status). This button goes dark, but the IRIS/MB ACTIVE indicator stays lit.

LOCK mode: All controls from this unit are disabled (lock status). Both this button and the IRIS/MB

ACTIVE indicator in the iris/master black control block go dark.

Using the RM Configuration menu under the Maintenance menu, the function of this button can be changed to switch only between FULL and LOCK modes. The RM Configuration menu operation is possible in any mode.

dSTANDARD button

When you press this button, the video camera is initialized to its standard state, and the button lights for several seconds. If you press the button while lit, the video camera retrieves the state before the button was lit.

eSpare button For future use.

fTest signal output select buttons

Press and light up one of these buttons to activate the test signal generator of the video camera and send the respective signals.

TEST: To send a signal to test the video circuits. You can select the kind of the test signal to be output using the RM Configuration menu under the Maintenance menu.

BARS: To send a color bar signal

HDC-900/950/930 Series Product Information Manual Chapter 7 Location and Function of Parts and Controls 132