Sony 950, 930, 900 Video signal select buttons, When a color viewfinder is used, Power indicator

7 7-1-2Rear Panel

1 Video signal select buttons

2 POWER indicator

3 ND filter selector

POWER R

G

e; H-POSI control wl WIDTH control wk V-POSI control wj HEIGHT control

wh CURSOR ON button

wg CURSOR STORE button wf RET 2 button

wd RET 1 button

B RET 2 RET 1

4 CC filter selector

ws RETURN SELECT knob 2

1 2 3 4 1 2 3 4

5 FILTER LOCAL button

FILTER LOCAL	2 3 4	H-POSI	V-POSI
	1	5	ON

MEMORY STICK

wa RETURN SELECT knob 1

6 UP TALLY switch

7 VF SCAN switch

8 SCREEN SIZE MARKER switch

9 CENTER MARKER switch

	ND
UP TALLY		C	D	WIDTH		HEIGHT	STORE	CURSOR
ON	B
	A		E				1	2	3
OFF	CC
VF	SCREEN SIZE CENTER			SAFETY	DISPLAY	MENU SELECT		VF DETAIL
SCAN	MARKER	MARKER		ZONE
16:9			ON	ON	ON			ON
	ON				OFF
4:3	OFF		OFF	OFF	MENU	CANCEL	ENTER
								OFF

ea VF connector

	w; Memory stick section
1	ql Back tally lamp
	qk CURSOR 1, 2, and
CALL	3 buttons
	qj CALL button
	qh VF DETAIL control
	qg VF DETAIL switch

qf Assignable switch

qd MENU SELECT control qs MENU SELECT switch qa DISPLAY switch

q; SAFETY ZONE switch

1

ed INTERCOM PROD/ENG switch ef INTERCOM volume control eg PGM 1/2 switch

eh PGM volume control ej MIC ON/OFF switch

Memo clip

es INTERCOM 1 and 2 connectors

	MIC		MIC
ENG PROD	OFF ON	ENG PROD	OFF ON
1	2	1	2
INTERCOM	PGM	INTERCOM	PGM
INTERCOM 1			INTERCOM 2

ej MIC ON/OFF switch eh PGM volume control eg PGM 1/2 switch

ef INTERCOM volume control

ed INTERCOM PROD/ENG switch

aVideo signal select buttons

Select the video output signal (R, G, or B) to the viewfinder. The R, G, and B buttons may be pressed individually or in combination. The signal corresponding to each pressed button will be output. When two buttons are pressed, the output of will consist of those two signals mixed together.

The video output to the monitor connected to the TEST OUT connector will always be the Y signal regardless of these buttons.

When a color viewfinder is used:

•When all three buttons are pressed, the output to the viewfinder and monitor will be the Y signal.

•When no button is pressed, the output to the viewfinder will be the color signals and to the monitor will be the Y signal.

bPOWER indicator

This indicator lights up or goes off as follows to indicate the power supply status:

Green: Power is being supplied to the HDC-900.

Red: The CAM PW button of the MSU-700A/750 Master Setup Unit or RCP-700 series Remote Control Panel is set to OFF.

Yellow: Power is being supplied to the HDC-900, but the VF PW button of the MSU-700A/750 Master Setup Unit or RCP-700 series Remote Control Panel is set to OFF, and power is not being supplied to the viewfinder.

Off: Power is not being supplied to the HDC-900.

HDC-900/950/930 Series Product Information Manual Chapter 7 Location and Function of Parts and Controls 79