Sony 900 Settings on the RM Configuration Menu, To select the Basic menu, Setting Contents Gory

7	Settings on the RM Configuration Menu
	The RM-B150 is provided with an RM Configuration
	Menu mode. This enables you to select and adjust the

function of the buttons and controls on the panel and to check various information. At the beginning of an RM Configuration menu operation, select ‘Basic menu’ or ‘Detail menu’ and proceed with operations as desired.

Operation

For menu operations, use the menu operation block of the unit to start the menu operation.

To select the Basic menu

Push the RM Configuration switch in the V direction. The menu display shows ‘Cbl Comp’ (the first category of the Basic menu).

To select the Detail menu

Push the RM Configuration switch in the V direction while holding the CANCEL/ENTER switch toward ENTER. The menu display shows ‘Mode Set’ (the first category of the Detail menu).

Note

The RM Diag category of the Detail menu is used to display various information, to check operations and reset the menu. For items for which the operation procedure differs, the procedure is discussed in the corresponding ‘Contents’ column.

To make settings on the menu

1. Turn the menu select knob until the required category appears on the display.

Example: Mode Set t ... t VR Setup

2. Push the CANCEL/ENTER switch toward ENTER to

register your selection made in step 1. The first subcategory of the selected category appears. Example: Knee

If there is no subcategory belonging to the selected category, the first setting (or display) item of that category appears on the display (proceed to step 5).

3. Turn the menu select knob until the desired subcategory appears on the display. Example: Knee t ... t Iris

4. Push the CANCEL/ENTER switch toward ENTER to register your selection made in step 3. (Pushing toward CANCEL reverses the operation.) The first setting item of the selected subcategory and its current setting appear.

Example: Ctrl: Abs

5. Turn the menu select knob until the desired setting (or display) item appears on the display. Example: Ctrl: Abs t ... t Min : Cls

For a setting item, make your setting.

6. Push the CANCEL/ENTER switch toward ENTER to register your setting made in step 5.

7. Turn the menu select knob until the desired category appears on the display. Example: Min : Cls t ... t Min : 22

8. Push the CANCEL/ENTER switch toward ENTER to register your setting made in step 7. (Pushing toward CANCEL cancels the setting in step 7.) To continue setting items, repeat steps 5 to 8.

To end the menu operation

Push the RM Configuration switch in the v direction.

Notes

•If an operation has not been made in Menu mode after one minute, the menu automatically exits.

•Values set on the RM Configuration menu are stored in memory when you exit the menu operation. Be sure to exit the operation before turning the power off.

Basic Menu (An underlined item under ‘Setting’

indicates the factory setting.)

Cate-	Subcategory	Item	Setting	Contents
gory
			10m,	Sets the cable
Cbl				length for the
	–	Len	50m,
Comp				cable compen-
			100m
				sation circuit
				Sets the bright-
	–	LED	10 to	ness of the
			99 (50)	LEDs on the
Bright				control panel
			10 to	Sets the bright-
	–	Disp		ness of the
			99 (50)
				menu display
			10 to	Sets the sound
	–	Lvl		volume of the
			99 (50)
Buzzer				buzzer
				Turns buzzer
	–	Out	On, Off	output on and
				off

HDC-900/950/930 Series Product Information Manual Chapter 7 Location and Function of Parts and Controls 131