Sony 930, 950 manual HDCU-900, HD Camera Control Unit, 1Front Panel

7	A PGM (program) control and switch: Adjust the
	program audio reception level. Select program
	1 or 2 with the switch.

B Line select switch: Select the intercom line.

PROD: Producer line

ENG: Engineer line

CLEVEL/TALK switch:

R/ON: The intercom headset microphone is turned on. The intercom audio reception level is adjusted with the INCOM control.

R/OFF: The intercom headset microphone is turned off. The intercom audio reception level is adjusted with the INCOM control.

F/OFF: The intercom headset microphone is turned off. The intercom audio reception level is adjusted with the INCOM/EAR LEVEL control on the front of the camera.

DINCOM (intercom) control: Adjusts the intercom audio reception level.

fCALL button

When you press this button, the red tally lamp of the RCP-700-series Remote Control Panel or the MSU- 700A/750 Master Setup Unit, will light. Use to call the operator of the RCP or MSU.

7-3.HDCU-900, HD Camera Control Unit

7-3-1Front Panel

1Red tally lamp

2 Green tally lamp

3 MIC switch

4 INTERCOM control

8 INTERCOM connector

7 CAMERA POWER switch and indicator

6 MAIN POWER switch and indicator

5CABLE ALARM indicators

aRed tally lamp

Lights when a red tally signal is received. When the CALL button on the video camera, MSU-700A/750 Master Setup Unit, RCP-700 series Remote Control Panel, etc. is pressed, this lamp will go out if previously lit, and light up if previously off. A supplied number plate may be mounted here.

bGreen tally lamp

Lights when a green tally signal is received. A supplied number plate may be mounted here.

cMIC (microphone selection) switch

Used to select the type of headphone microphone being used, or to turn the microphone input off. DYNAMIC: for a dynamic microphone

OFF: to turn the microphone input off

CARBON: for a carbon microphone

Note

The intercom line is selected via a switch on the internal AT board.

dINTERCOM (intercom volume adjustment) control

Adjusts the intercom input level.

Note

The program audio mix volume is adjusted using the internal AT board.

eCABLE ALARM indicators

SHORT (red): This indicator lights when there is a short circuit between a power supply line and the sheath of the optical fiber cable, or when the two power supply lines are shorted. When this indicator lights, the power supply is shut off.

OPEN (red): Lights when there is not a camera connected via an optical fiber cable to the CAMERA connector on the rear panel. It flashes to warn about insufficient optical reception status of the optical fiber cable.

fMAIN POWER switch and indicator Turns on or off the power to the entire system, consisting of the HDCU-900, a video camera, an RCP- 700 series Remote Control Panel connected via the REMOTE connector, etc. Setting the switch to the " "

HDC-900/950/930 Series Product Information Manual Chapter 7 Location and Function of Parts and Controls 87