Sony 950 Rack at the screw holes at 31.75 mm, Fasten the screws loosened in step, Installation

2	(2) Attach the rear bracket to the outside of the rear
	of the rack at the screw holes at 31.75 mm
	intervals, using screws (d).
5.	Fasten the screws loosened in step 3.
6.	Pull the rails out.

7.Insert the inner member to the outer member while pushing against the stopper, and then fully push the unit into the rack.

Warning for Safety Purpose: It takes two or more people to mount a unit into a rack. Mounting the unit into a rack by yourself can cause back or other injuries.

8.Push the unit into the rack, and secure the front

panel to the rack with screws (+RK M5 x 16 to 20) and washers (φ 5).

Installation

1.Secure the RMM-301 in the 19-inch EIA standard rack with the four B5 screws (6 mm or longer).

57.2 mm

B5 screw

(6 mm or longer)

RMM-301

B5 screw

(6 mm or longer)

2.Secure the unit with the supplied four screws (B4 x 6) and the four washers.

W4

B4 x 6

W4

HDCU-950

The two HDCU-950 can be mounted in parallel in a 19- inch EIA standard rack by using the rack mount adapter RMM-301 (optional). (Three-unit height)

B4 x 6

Warning

•If the rack falls due to the weight of the equipment, it may cause death or major injury. To prevent the rack from falling or moving, be sure to fix the rack to the floor.

•If the rack falls, death or serious injury may result. When attaching the unit, be sure to fix the rack to the floor and be careful not to attach at a height of 1.2 m or higher from the floor.

Caution

•Use the specified rack mount adapter. If not, injury could occur by drop of the unit because strength of the shelf board is not enough.

•Mount the unit with more than two persons. A one- man job may cause injury.

•Be careful not to catch your finger or hand in the rack mount rail.

•Mount in the rack in a stable position. Injury could occur by drop of the unit in unbalance condition of

HDC-900/950/930 Series Product Information Manual Chapter 2 Total System 40