Sony 900, 930, 950 Intercom volume control, Intercom line selector, Prod producer Producer line

7	If the CAM PW button on the Remote Control Panel or
	Master Setup Unit is pressed, only power to the
	camera is turned off, and the CAM indicator alone

goes dark.

Note

Standby power is kept supplied even when the POWER switch is set to off. The main power switch is provided on the power unit behind the front cover. If you open the front cover and set the main power switch to off, power cannot be turned on with the POWER switch on the front panel.

d MIC/PGM (microphone/program audio) switch ON: To turn on the headset microphone

OFF: To turn off the headset microphone

PGM (program): To output the program audio to the intercom connector

eIntercom volume control

To adjust the intercom input level

fIntercom line selector

Select the intercom line to which the intercom signal is to be connected:

PROD (producer): Producer line

PRIV (private): The producer line and engineer line are disconnected, and communication is possible only between the HDCU-950 and the connected camera.

ENG (engineer): Engineer line

gIntercom connector (XLR 5-pin) Connect a headset.

Note

To use a headset with a plug other than an XLR 5-pin plug, consult a Sony service or sales representative.

7-4-2Rear Panel

1HD SDI OUT 1 and HD SDI OUT 2 connectors

2 REFERENCE connectors

3SYNC OUT connector

			4 PROMPTER connectors (RET4)
SD output block (DIF board)				5 MIC1 and MIC2 connectors
				6 CAMERA connector
	REFERENCE		PROMPTER	CAMERA
RC				MIC1
SD SDI
OUT 1
SD SDI	HD SDI	RET1
OUT 2	OUT 1
			SYNC OUT	MIC2
PIX	HD SDI	RET2
OUT	OUT 2
WF	MONI	RET3	RCP/CNU WF MODE
OUT
INCOM/TALLY/PGM			MIC REMOTE
				qf AC IN connector
7 Expansion slot				qd WF MODE connector
			qs RCP/CNU connector
			qa MIC REMOTE connector (WF REMOTE)
		q; RET1, RET2, and RET3 connectors

9MONI connector

8INCOM/TALLY/PGM connector

aHD SDI OUT 1 and HD SDI OUT 2 (HD serial digital interface output 1 and 2) connectors

(BNC type)

The signal from the video camera may be output as HD-SDI signals.

bREFERENCE connectors (BNC type)

Input an HD tri-level reference sync signal or SD reference sync signal (black burst signal) to either of the two connectors. The input signal is output from the

other connector as-is (loop-through output). If loop- through output is not used, terminate the unused connector with 75 ohms. The type of reference signal is selected using the switch on the internal AT board, or using the MSU-700A/750 Master Setup Unit.

Note

To use the VBS signal of the HKCU-951 SD Encoder Unit (SC phase lock is required), use an SD reference sync signal (black burst signal).

HDC-900/950/930 Series Product Information Manual Chapter 7 Location and Function of Parts and Controls 95