Heatiator owner manual Heatilator I80 CAN-US 4013-203Rev F 04/08

•For installations utilizing an ST1175 or ST475 Square Termination Cap the last chimney section must not be more than 4-1/2 in. (114 mm) below the chase top. See Figure 6.6.

	Flashing Collar
Cap Standoff		2 in. (51 mm) min.
				4-1/2 in.
1-1/2 in.
(38 mm) min.			(114 mm)

•For chase installations you can use a TR11 or TR444 Round Termination Cap, a TR11T or TR442 Round Telescoping Termination Cap, an ST1175 or ST475 Square Termination Cap, or a TCT1175 Terra Cotta Termination Cap.

•For installations utilizing a European Copper Series Termination Cap, See Figure 6.8.

overlap Top of Pipe max.

Figure 6.6 Installing an ST1175 or ST475 Square Termination Cap

•For installations utilizing an TCT1175 Terra Cotta Cap the last chimney section must be between 7 in. (178 mm) below the chase top and 2 in. (51 mm) above. See Figure 6.7.

Cap Base

bracket (8)

screw (8)*

(cap inner flue)

1-1/2 in. (38 mm) min. overlap

{

The last section of pipe must stop between the distances given below.

2 in. (51 mm) above top of the chase.

chimney top

chase top

(metal or masonry) SL pipe inner flue

2 - 6 in. (51-152 mm)

2 in. (51 mm) typical

Top of Pipe

7 in. (178 mm) below top

of the chase.

Figure 6.8 Installing a European Copper Series Termination Cap

(CT11-King shown, available in US only)

Figure 6.7 Installing a TCT1175 Terra Cotta Cap (available is US only)

•Install termination caps following instructions provided with them.

28 Heatilator • I80 CAN-US • 4013-203 Rev F • 04/08