Heatiator I80 owner manual Secure the Fireplace, Install the Refractory, Position the Fireplace

B. Secure the Fireplace

•Position the Fireplace

This fireplace may be placed on either a combustible or noncombustible continuous flat surface. Follow the in- structions for framing in Section 3.D. Slide the fireplace into position. Be sure to provide the minimum air clear- ance at the sides and back of the fireplace assembly. See Section 3.B.

WARNING

Fire Risk!

•Prevent contact with sagging, loose insulation.

•Do NOT install against vapor barriers or exposed insulation.

•Remove smoke shield by removing five screws. See Figure 4.7. Smoke shield is located at top of fireplace front.

•Remove screens by removing screw from the end of each screen rod. See Figure 4.8.

	Smoke Shield
Front Face
Skip	Skip
Remove these screws.
Figure 4.7 Removing Smoke Shield

C. Install the Refractory

We recommend two installers for hearth stone and refrac- tory installation!

•Remove back refractory from outside of fireplace by bending tabs up and lifting refractory out of brackets. See Figure 4.5. Bend tabs back down out of the way. See Figure 4.6. Do not remove screws or brackets from fireplace. If brackets are removed, fill holes in outer shell with screws. Repeat this process to remove side refractories.

•

Figure 4.5 Unpacking Back Refractory

Figure 4.8 Removing the Screen Rods

Remove hearth stone by removing three corrugated shipping spacers (Figure 4.9). Lift hearth stone out of fireplace. See Figure 4.10.

Figure 4.9 Shipping Spacers

Figure 4.6 Bending Refractory Shipping Tabs Back Down

Figure 4.10 Lifting Out the Hearth Stone

Heatilator • I80 CAN-US • 4013-203 Rev F • 04/08 15