Heatmaster 201 User Guide, Setting the temperature of the hot water, Fault, Reset the appliance

SETTING THE PARAMETERS

Setting the temperature of the hot water:

(Temperature of the hot water)

-Press “Mode”: “PARA” comes up on the screen.

-Press “Step”: the first digit is 1 and the last two digits indicate the current temperature setting for the hot water.

-To change this temperature, press the “+” or “-” keys until the temperature indicated by the last two digits is the desired temperature.

-Press “Store” to save the setting.

-Press “Mode” twice to return to Standby mode (normal operating mode).

Enabling and disabling hot water mode:

(hot water)

-Press “Mode”: “PARA” comes up on the screen.

-Press “Step” twice: the first digit is 2 and the last two digits indicate the current setting:

00 = disabled; 01 = enabled.

-To change this parameter, press the “+” or “-” keys until you reach the desired value:

00 = disabled; 01 = enabled.

-Press “Store” to save the setting.

-Press “Mode” twice to return to Standby mode (normal operating mode).

Enabling and disabling central heating mode:

(heating)

-Press “Mode”: “PARA” comes up on the screen.

-Press “Step” three times: the first digit is 3 and the last two digits indicate the current setting:

00 = disabled; 01 = enabled.

-To change this parameter, press the “+” or “-” keys until you reach the desired value:

00 = disabled; 01 = enabled.

-Press “Store” to save the setting.

-Press “Mode” twice to return to Standby mode (normal operating mode).

Setting the temperature of the central heating:

(the maximum temperature for the heating circuit)

-Press “Mode”: “PARA” comes up on the screen.

-Press “Step” four times: the first digit is 4 and the last two digits indicate the current temperature setting for the central heating.

-To change this temperature, press the “+” or “-” keys until the temperature indicated by the last two digits is the desired temperature.

-Press “Store” to save the setting.

-Press “Mode” twice to return to Standby mode (normal operating mode).

Fault:

The temperature setting of the appliance and the safety functions of its parts are constantly monitored by a microprocessor controller (MCBA). In the event of a fault, this MCBA disables the appliance and displays an error code: the screen flashes and the first character is an “E” followed by the fault code, (see the list of faults on page 16).

Reset the appliance:

-Press “Reset” on the screen.

-If the fault code appears again, contact your installer.

	USER GUIDE
Setting the temperature of the hot water
Stand by mode
1 X	1 X
Mode	Store
1 X	2 X Stand
		by
Step	Mode	mode
	1 X

Store

Enabling and disabling hot water mode

Stand by mode
1 X	1 X
Mode	Store
2 X	2 X Stand
		by
Step	Mode	mode
	1 X

Store

Enabling and disabling central heating mode

Stand by mode
	1 X		1 X
	Mode		Store
		3 X			2 X	Stand
							by
				Mode			mode
		Step
			1 X

Store

Setting the temperature of the central heating

Stand by mode
	1 X		1 X
	Mode		Store
		4 X		2 X	Stand
					by
				Mode	mode
		Step
			1 X

Store

Fault Reset the appliance

Status T°

1 Reset

3