Model
2-9. HEATING ELEMENTS
Heating elements are available for 208, 480 and 230 volts. Check data plate to determine correct voltage.
Checkout:
If the shortenings temperature recovery is very slow or at a slower rate than required, this may indicate defective heating element(s). An ohmmeter will quickly indicate if the elements are shorted or open.
1. Remove electrical power supplied to the frypot to be worked on.
To avoid electrical shock or property damage, move the POWER switch to OFF and disconnect main circuit breaker, or unplug cord at wall receptacle, to the frypot to be worked on. Be aware the other controls will have power.
2.Remove control panel.
3.Perform an ohm check on one element at a time, with wires disconnected from element. If the resistance is not within tolerance, replace the element.
Voltage | Wattage | Resistance Ohms (cold) |
208 | 7333 | 5.6 |
240 | 7333 | 6.9 |
480 | 7333 | 27.5 |
Replacement: |
|
|
Refer to figure
1.Drain the shortening from the frypot.
2.Remove the high limit bulb holder from the heating element inside the frypot.
405 |
